Pentax PC35AF PC35AF Manual - Page 5
move/position
View all Pentax PC35AF manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 5 highlights
4 X Exposure compensation Care should be taken when photographing people under back-light situations where the sun or a bright sky or a window is behind the subject, for the Pentax PC35AF auto exposure system will tend to underexpose the subject. To compensate for this type of situation, the shutter should be released while simultaneously keeping the exposure compensation button depressed; the subjects will then be exposed as close as possible to normal. Uncompensated Compensated X Flash photography Partially depress shutter button, should the beep warning activate and be accompanied by O the simultaneous lighting of the ORANGE lamp in the upper section of the viewfinder, this indicates a lack of sufficient light and the possibility of camera shake, due to the slow shutter speed involved. The incorporated flash unit of the camera will help to overcome this problem by compensating for the poor light. Ignoring the special warning mechanism provided, and depressing the shutter will cause camera shake due to the slow-shutter speed and/or under exposed pictures. 2 III ill I fVflt i.l f Push down when not in use -_, 1. Push flash pop-up release found at the camera base -the flash will spring up into place and automatically begin to charge. 2. Prior to making exposures, allow the flash ready lamp to stay on for several seconds for a full charge. When the flash unit is no longer required, simply depress the head into the camera body: it will lock automatically and return the camera to normal mode. Utilize flash as a supplementary light source in taking photographs in the daylight; In photographing a person/people appearing in the shade-under trees, heavy foliage, etc., without the use of flash-assisted synchronization, the face(s) of subjects appear somewhat darker in the final photograph. Flash synchronization will help greatly in "lighting" up the dark areas of the face, and rendering a pleasing overall photographic result to the subject. X Focus locking technique When subject(s) appear outside the auto focus framing of the viewfinder, the main subjects get out of focus; to remedy the situation, the following focus lock procedure is recommended: 1. Center your subject for focusing within the auto focus frame of the viewfinder. Partially depress the shutter button, which will freeze the focus temporarily. 2. Confirm position of the zone focusing marker indicator in the viewfinder. 3. While shutter button is partially depressed, frame your picture and then release the shutter, • With the shutter button partially depressed, focus control is frozen at the position of the indicator within the zone focusing marker area. Focusing will be unlocked when pressure upon the button is released. • After depressing the shutter button partially, if you remove your finger from the shutter button in order to stop taking a photograph, the shutter button may remain depressed. In 2 that event, further depress the shutter button and release the shutter. The button will then return to the original position. ri +1 .4 X Difficult auto focusing subjects/situations Although the Pentax PC35AF auto focusing system is extremely accurate and reliable, certain difficult situations will create problems for the system unless compensation is provided. A common solution will be to focus upon a subject located near the actual subject being photographed. and freeze the distance. Then move/position the camera to point considered best for framing purposes. Some typical problems which may be encountered when the following subjects/ situations are within the viewfinder's auto focus frame: 1. Non-reflective objects-dark hair or a black telephone-which possess poor reflective qualities; 2. Wire-netting, latticework, and an iron exercise-bar-all with minimal light reflecting qualities; 3. When fluorescent lamps, T.V. sets, sunlight coming through the trees, or strong backlighting conditions are found in and around the auto focus frame; 4. Glass panelling, mirrors, and/or a car body-all possessing strong reflective qualities; 5. Trains and cars and other fast-moving objects; 6. Water jets, water surfaces, smoke, flame/fireworks., and other vaguely shaped objects.