Pfaff 72 Owner's Manual - Page 10

Winding, Bobbin

Get Pfaff 72 PDF manuals and user guides View all Pfaff 72 manuals
Add to My Manuals
Save this manual to your list of manuals

Page 10 highlights

DR 859 Winding the Bobbin Disengage the sewing mechanism and raise the spool pins to the vertical position. Place a spool of thread on one of the spooi pins and a bobbin on the bobbin winder spindle, making sure that the key at its base enters the slot in the bobbin. Pass the thread through the righthand thread guide, down and around the thread retainer stud, and up to the bobbin. Wind a few turns of thread on the bobbin in clockwise direction. Push the bobbin to the right and start the machine. The bobbin winder will stop automatically when the bobbin is full. Press the bobbin to the left and remove it from the spindle. Then tighten the stop motion knob again. The amount of thread to be wound on the bobbin is regulated by turning the adjusting button accordingly. Set the button at position A for the mim mum amount of thread, or at position B for the maximum. The button can be turned to the desired position after loosening its set screw with a screwdriver. 9 1 AB

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
1
DR
859
Winding
the
Bobbin
Disengage
the
sewing
mechanism
and
raise
the
spool
pins
to
the vertical
position.
Place
a
spool
of
thread
on
one
of
the
spooi
pins
and
a
bobbin
on
the
bobbin
winder
spindle,
making
sure
that
the
key
at
its
base
enters
the
slot
in
the
bobbin.
Pass
the
thread
through
the
righthand
thread
guide,
down
and
around
the
thread retainer
stud,
and
up
to
the
bobbin.
Wind
a
few
turns
of
thread
on
the
bobbin
in
clockwise
direction.
Push
the
bobbin
to
the
right
and
start
the
machine.
The
bobbin
winder
will
stop
automatically
when
the
bobbin
is
full.
Press
the
bobbin
to
the
left
and
remove
it
from
the
spindle.
Then
tighten
the
stop
motion
knob
again.
The
amount
of
thread
to
be
wound
on
the bobbin
is
regulated
by
turning
the
adjusting
button
accordingly.
Set
the
button
at
position
A
for the
mim
mum
amount
of
thread,
or
at
position
B
for
the
maximum.
The
button
can
be
turned
to
the
desired
position
after
loosening
its
set
screw
with
a
screwdriver.
A
B
9