Pfaff creative vision 5.0 Owner's Manual - Page 46
Sensormatic, free-motion, Spring foot free-motion, Presser foot pressure E, Presser foot height
View all Pfaff creative vision 5.0 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 46 highlights
Pfaff HD screen Sensormatic free-motion Activate to set the machine in Sensormatic freemotion mode for presser foot 6A. The feed dogs will lower automatically. When sewing free-motion at low speed the presser foot will raise and lower with each stitch to hold the fabric on the stitch plate while the stitch is being formed. At higher speed, the presser foot floats over the fabric while sewing. The fabric must be moved manually. Skipped stitches can occur if your fabric moves up and down with the needle as you are stitching. Lowering the presser foot height will reduce the space between the presser foot and the fabric and eliminate the skipped stitches. Note: Be careful not to reduce the presser foot height too much. The fabric must still move freely under the presser foot. To adjust the presser foot height in Sensormatic free-motion mode, long touch the icon (D) and make adjustments in the pop-up. Note: Make sure that the IDT is disengaged. Spring foot free-motion Activate to set the machine in Spring foot free-motion mode. The feed dogs will lower automatically. A spring foot will raise and lower with each stitch to hold the fabric on the stitch plate while the stitch is being formed. Note: Make sure that the IDT is disengaged. The open-toe free-motion feet are optional and can be purchased at your local authorized PFAFF® dealer. Do not use if Sensormatic free-motion is activated, since the needle might damage the presser foot. The open-toe free-motion feet, or any spring foot with light grey plastic housing, can also be used for embroidery. Presser foot pressure (E) In most cases, you do not need to adjust the presser foot pressure. Specialty techniques may require an adjustment. The higher the number the more pressure on the fabric. Presser foot height embroidery (F) Adjust the height of the presser foot in embroidery stitch-out mode. Some embroideries may build up under the presser foot. If there is not enough space between the presser foot and the embroidery, the top thread will form loops on the underside of the embroidery. Increase the presser foot height in small steps until the embroidery moves freely under the presser foot. 3:10 D E F ABC Pop-up for set presser foot height in Sensormatic freemotion.