Pfaff hobbylock 786 Owner's Manual - Page 28
downwards.
View all Pfaff hobbylock 786 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 28 highlights
Changing the needles Pull out the mains plug. Lower the sewing foot. Turn the hand wheel in the direction of the arrow until the needle bar is at its highest position. Use the needle change tool from the accessories (see p. 31, tern 11) as follows: Insert the needle in hole M of the needle change tool. Loosen the set screw of the needle with the screw driver. Remove the needle by pulling it downwards. I K Inserting the needle Insert the needle in hole M of the needle change tool in such a way that flat side K of the needle shank faces surface L of the needle change tool. Then push the needle up into the needle holder as far as it will go. Tighten needle set screw securely. Remove needle change tool from the needle. LM I \\ Notes: The following needles are used on these machines: System 130/705 H (75-90) Although the correct needle size depends on the material and the thread size used, we recommend needle size 75-90. An incorrectly inserted needle will cause thread breakage and skipped stitches. -,/y - ___;_ . \c;;-rI - Changing the knives are available as spare parts. PKunlilvoesut the mains plug. Disengage the upper knife, see page 21. 26