Pfaff hobbylock 786 Owner's Manual - Page 9

I n E1 H Opening and closing looper cover and work support Push looper cover fully to the right. hold it, and swing it down. To close the looper cover, push it up until it locks. To open work support 12, push it to the left. To close the work support, push it to the right until it locks. A threacing diagram is fixed to the machine behind the looper cover. This diagram shows the different threading paths by different colors (see Fig. A). 1 Threading the guide wire of the thread spool stand and the thread guides behind the carrying handle The machine must be threaded correctly. First pull the respective threads through their corresponding guides (Figs. B and C). Then thread the tensions in the following sequence: 1. right looper (red) 2. left looper (yellow) 3. right needle (green) 4. left needle (blue) C Figure B shows the threading path of the individual threads for thread guides 18. For threading the guides oehind carrying handle 2, the handle must be pulled up (Fig. C). After threading, carrying handle 2 must be pushed down again. 7