Pfaff smart 100s Owner's Manual - Page 17
ê=4
View all Pfaff smart 100s manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 17 highlights
Threading the upper thread This is a simple operation but it is important to carry out correctly. - Start by raising the needle to its highest point (1), and also raise the presser foot to open the tension discs. (2) 3ê=4 IVote: For safety, it is strongly suggested you turn off the power before threading. Lift up the spool pin. Place the spool of thread on the holder 1 with the thread coming off the spool as shown. For small thread spools, place small side of spool cap next to spool.(3) Draw thread from spool through the upper thread guide. (4) Guide thread around thread guide (5) pulling thread through pre tension spring as illustrated. - - Thread tension module by leading thread down right channel and up left channel (6). During this process it is helpful to hold the thread between the spool and thread guide (4). At the top of this movement pass thread from right to left through the slotted eye of the take-up lever and then downwards again. (7) Pass thread behind the flat horizontal thread guide (8) Now take thread behind the thin wire needle clamp guide and then down to the needle which should be threaded from front to back Pull about 6-8 inches of thread to the rear beyond the needle eye (9) 14