Philips 17PF9936/37 User Manual - Page 41

REMOTE CONTROL USE WITH ACCESSORY DEVICES - SEARCH METHOD Your TV remote can be set to work various external devices such as VCRs, Cable Boxes, Satellite Receivers, DBS, DVD, etc. by what is called the search method of remote control programming. If the "Remote Code" number method shown on the previous page did not set your remote to work your external device, then follow the easy steps listed below. Please read steps 1-4 before beginning. 1 Press the POWER button on the device your are attempting to program 1 to turn it ON. 2 Place the TV/DVD/ACC Mode Switch in the proper position. 3 Press the • RECORD and the AUTO SOUND buttons simultaneously and hold them down. The remote will continue to send programming codes, one ever 1.5 seconds. 4 The device will begin to change channels after the remote identifies the correct code. When the channels start to change release the • RECORD and AUTO SOUND buttons. The remote should be ready to operate the device. HELPFUL HINT This method can take several minutes to perform. Don't let the device scan up more than five channels. If you do the remote may pass up the right code and another search cycle will have to be repeated. If no channel change happens within two minutes, repeat steps 1-4. Should a channel change still not occur, the remote will not work the desired device. NOTE: Setting up the remote is for use with external accessory devices only and not for use with other television brands. Satellite Receiver 0809 07 Cable Converter 06 VCR 06 070809 070809 3 2 3 PIP POSITION CC TV PROG. LIST CLOCK DVD SLEEP ACC TV/VCR SOURCE FORMAT A/CH AUTO SOUND MENU ACTIVE CONTROL AUTO PICTURE SURR. SOUND 4 VOL PC MUTE CH RADIO TV HD 1 2 3 456 789 STATUS/EXIT 0 SURF 41