Philips 30PW8402 Quick start guide - Page 7

5 CABLE BOX CONNECTIONS If your cable signal uses a cable box Models 26PW8402/37 and 30PW850H or decoder, follow the easy steps will not have HDMI Inputs. below to complete the connection. Cable Box (w/RF In/Outputs): Cable Box (w/RF In/Outputs): This connection will be mono. Cable Signal IN from the 1 Connect the Cable Company supplied cable to the signal IN(put) plug on the back of the Cable Company Cable Box. 2 Using a separate round coaxial cable, connect one end to the OUT(put) (TO TV) plug on TO TV/VCR the back of the Cable Box. CABLE IN VIDEO AUDIO IN SPDIF IN OUT R L IR DVD-D OUT S-VIDEO AUDIO OUT Y Pb Pr USB TV PASSCARD OPTICAL SPDIF Jack Panel Back of Cable Box 3 Connect the other end of the round coaxial cable to the 75Ω input on the back of the televi- sion. Screw it down finger tight. NOTE: If applicable, set the OUT- PUT CHANNEL SWITCH on the Round 75Ω back of the cable box to CH 3 or 4. Coaxial Cable Tune the TV to the same channel and Jack Panel Back of TV change channels at the cable box. In some cases, the cable box will auto- matically tune to either channel 3 or 4, Cable Box (w/Audio/Video Outputs): change channels until the picture appears. Cable Box with Cable Box (w/Audio/Video A/V Outputs Outputs): This connection will supply Stereo sound. 4 Connect the Cable Company supplied cable to the cable signal IN(put) plug on the back of Cable Signal IN from the Cable Company 24 the Cable Box. VIDEO AUDIO IN SPDIF IN OUT 5 Using a RCA type Video Cable, connect one end of the cable to the Video (or ANT, your cable box may be labeled differently) Out jack on the cable box and the other end to the AV1 Video TO TV/VCR CABLE IN R L IR DVD-D OUT S-VIDEO AUDIO OUT Y Pb Pr USB TV PASSCARD OPTICAL SPDIF Audio Cables L (White) & R (Red) Video Cable (Yellow) Input on the TV. 6 Connect one end of the Audio Left and Right Cable to the left and right Audio Out L & R jacks on the cable box. Connect the other end to the AV1 Audio L & R Input jacks on the TV. Jack Panel Back of TV NOTE: Press the AV button or use the CH+ or CH- on the TV remote control to tune to the AV1 channel for the cable box signal. Once tuned, change channels at the cable box, not the tele- vision.