Philips 32HF7544D User manual - Page 6

BASIC TELEVISION CONNECTION ANTENNA CONNECTION · Connect the antenna or RF cable signal to the 75 ohm RF 'F' connector socket located on the TV. MAINS CONNECTION · Ensure that the mains voltage and frequency are correct. Please refer to the product labelling and documentation. Note : The power button on the TV does not disconnect the television from the AC mains. It toggles the TV between on and standby mode. To completely turn off the AC mains power, you must unplug the AC mains plugs from the wall socket. POWER FORMAT CLOCK SLEEP GUIDE AV SAP CC INFO AUTO SOUND A/D AUTO PICTURE MENU OK MUTE VOL CH 123 456 789 A/CH 0 REMOTE STANDBY POWER FRONT PANEL STANDBY POWER (EXAMPLE) SWITCHING ON THE SET · Press the power button on the TV or on one of the optional remote controls to switch the TV set on. Note : If the TV is in commercial mode, it might not respond to the front panel or the remote control. Please refer to the section on TV Installation and TV Setup Menu in this documentation for more informaton. USE & CARE OF OPTIONAL REMOTE CONTROLS To load the supplied batteries into the remote control ; - Remove the battery compartment lid from the back of the remote control. - Insert two AA-sized batteries into the battery compartment, making sure the positive + and negative - polarity line up correctly as indicated inside the case. - Reattach the battery compartment lid. Note : Always remove batteries from the remote control if it is not used for a long period of time. This is to prevent damage to the remote control due to battery leakage. 6 ITV_Nafta.indd 6 2006-10-05 5:41:21 PM