Philips 42FD9954 User manual - Page 9

MAINS INLET L L L RS232 R R R DVI-D VGA 2 VGA 1 VGA 1 VGA 2 RC OUT DVI-D AV 2 L L CVBS Pb H L Y/C R R Y Pr V R Connect Peripheral Equipment You may connect 3 possible VGA sources (VGA1, VGA2 or DVI-D) and 3 possible video sources (AV1, AV2 and AV3) to the monitor. The following diagrams show you where you can connect your peripheral equipment. Note: in case the monitor is operating in combination with an electronic receiver box (video mode), the AV inputs on the monitor will be disabled and the VGA2 connector becomes an output. Equipment with Y/C-SVHS output connectors ~ MAINS RS232 L R DVI-D VGA 2 AUDIO VGA 1 VGA 1 VGA 2 RC-OUT DVI-D AV2 L CVBS B/Pb/Cb H L R R Y/C S-VHS AUDIO IN AUDIO IN G/Y/Y R/Pr/Cr V AV2 AV1 AV3 AUDIO IN & Connect the video cable to the AV2 connector. é Connect the audio cables to the equipment's AUDIO L and R sockets and to the AUDIO L and AUDIO R AV2 sockets on the monitor. Equipment with CVBS output connectors ~ MAINS RS232 L R DVI-D VGA 2 AUDIO VGA 1 VGA 1 VGA 2 RC-OUT DVI-D AV1 CVBS B/Pb/Cb H L L R R Y/C S-VHS AUDIO IN AUDIO IN G/Y/Y R/Pr/Cr V AV2 AV1 AV3 AUDIO IN & Connect the video cable to the AV1 connector. é Connect the audio cables to the equipment's AUDIO L and R sockets and to the AUDIO L and R AV1 sockets on the monitor. Equipment with Component Video Output connectors ~ MAINS RS232 L R DVI-D VGA 2 AUDIO VGA 1 VGA 1 VGA 2 RC-OUT DVI-D AV3 CVBS B/Pb/Cb H L L R R Y/C S-VHS AUDIO IN AUDIO IN G/Y/Y R/Pr/Cr V AV2 AV1 AV3 AUDIO IN Note: AV3 can handle the following video signals:YCbCr, HD-YPbPr and HD-RGB. The discrimination between the various input formats and the appropriate video processing is done automatically. It is however possible to overrule the automatic detection. See Setup menu, p. 8. & Connect the video cables of your equipment with YPbPr output with composite sync on Y, or of your equipment with YCbCr output with composite sync on Y to the YPbPr, resp.YCbCr input AV3 IN sockets of the monitor. é Connect the video cables of your equipment with RGB output with separate Horizontal and Vertical sync to the RGB input sockets and to the H and V sockets AV3 of the monitor. " Connect the audio cables to the equipment's AUDIO L and R sockets and to the AUDIO IN L and AUDIO IN R AV3 sockets on the monitor. Note: when High Definition signals are inputted to the monitor via the YPbPr/RGB input, the monitor switches to the HD Video Mode. The following HD and SD video modes are supported by the monitor on the YPbPr, RGB and VGA2 HD input: 1920x1080/60I 1280x720/60P 720x480/60P 720x576/50P The following SD video modes are supported by the monitor on theYCbCr input: 720x480/60I 720x576/50I Note: you should make the correct selection for AV3 in the Setup menu, p. 8. 9