Philips 49PFL6921 User manual - Page 10

Installing the Stands 1 Remove the tape on the bottom of the TV set and the plastic bag. 10 .English Lifting the TV Set Carefully lift the TV set as shown in the illustration and place it onto a stable, level surface. 2 Fasten the matching stand to the TV with 2 screws (included). While fastening the screws, hold the stand to prevent it from falling. Also, make sure to attach the stand parallel to the bottom of the TV set, as shown in the enlarged illustration. Line of this stand Removing Cardboard Remove the cardboard attached to the screen. You are now ready to set up and enjoy your Philips TV. 2 screws required Line of this unit 3 Fasten the other stand to the TV with 2 screws. While fastening the screws, hold the stand to prevent it from falling. Line of this stand 2 screws required Line of this unit 4 Both stands should now be securely fastened. Installing the Remote Control Batteries Note(s) • A wide open space is recommended for assembly. • A Phillips-head screwdriver is required to fasten the stands to the TV set. • When attaching the Stand, ensure that All Screws are tightly fastened. If the Stand is not properly attached, it could cause the Unit to fall, resulting in injuries as well as damage to the Unit. • To remove the Stand from this Unit, unscrew the Phillips-head screws by reversing the procedure. Be careful not to drop the Stand when you remove it. 1 Slide the battery cover off the back of the Remote Control. 2 Insert the two supplied batteries (AAA, 1.5V). Be sure the + and - ends of the Batteries line up with the markings inside the case. 3 Slide the cover back into position. Note(s) • Remove the Batteries if not using the Remote Control for an extended period of time. Continued on next page.