Philips 50PFL5601 User manual - Page 19
Use your TV, Switching on your TV and putting it in standby mode, Adjusting volume, Switching channels
View all Philips 50PFL5601 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 19 highlights
50PFL5601 serial numbers beginning with DS1 and DS2 3 Use your TV Switching on your TV and putting it in standby mode TV Remote Control Switching channels TV Remote Control 19 .English To turn the TV on from standby or off to standby • Press on the TV or the remote control. Note(s) • Energy consumption contributes to air and water pollution. When the AC power cord is plugged in, your TV consumes energy with a very low standby power consumption. Adjusting volume TV Remote Control To select channels by using CH / or CH + / - • Press CH (up) / 㸦down) on the TV or press CH + / - on the remote control. To select channels by using the NUMBER buttons Digital TV operation • For digital channels, press a number followed by a dot "•" and the corresponding sub channel number. -When selecting digital channel 1 1. 1 Be sure to press • before entering the subchannel number. To decrease or increase volume • Press VOL / on the TV or press VOL + / - on the remote control. VOL (-) : Volume down VOL (+) : Volume up To mute or unmute sound • Press on the remote control to mute the sound. • Press again or VOL + / - to recover the original sound. Cable / NTSC (Analog) TV operation -When selecting cable or analog channel 1 1 Press PREV.CH to return to the previously viewed channel. Note(s) • To select the non-memorized channels, use the NUMBER buttons. • Channel not available or No signal will appear on the TV screen after the subchannel broadcast is over. • Audio only message will appear on the TV screen, when you receive only sound signal. Continued on next page.