Philips 55PFL7505D User manual - Page 12
Switching on and set up the TV
UPC - 609585189676
View all Philips 55PFL7505D manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 12 highlights
English Switching on and set up the TV Before you switch on the TV, check that the AC power cord is properly connected. Press . POWER at the right side of the TV, or press . (Standby-On) on the remote control. The TV normally takes 25-30 seconds to start up and the following screen appears the first time you turn on the TV. After you read a welcome screen, follow the on-screen instructions to select your language and complete your TV setup. Installation takes approximately 20 minutes. Select your menu language with the Up/Down buttons on your remote control, press the OK button to proceed. ● English ● Français ● Español Press Î or ï to select the desired mode for energy saving, then press OK. Location Home is recommended for normal home use. In the Retail Store location all settings are fixed. Retail store Home Select [Picture A] or [Picture B] by pressing Í or Æ that is the most pleasing to you, then press OK.You see 5 different pictures to be completed. Which side of the picture do you prefer? Cancel Picture A Picture B Press Í or Æ to select [Store], then press OK. Store your preferences. Cancel Store Press OK to finish [Settings assistant]. The TV has learned your preferences. Exit Press Í or Æ to select [Finish], then press OK. Finish the Setup. Note • If you are not receiving a signal from your cable service, contact the CATV provider. • If you press . during autoprogram, an installation will be canceled except the language selection. • The initial autoprogram function can be executed for either [Antenna] or [Cable] only once.When you change the connection (Antenna / Cable), set autoprogram again. (Refer to page 26.) Select [Retail store] if you want backlight to be brighter. Select [Home] to reduce the power consumption. You must set [Home]. Otherwise, the settings of picture and sound quality you adjusted will not be memorized after you turn off the unit. • Select [Retail store], the unit will be set up with predefined setting for retail displays. In this setting, the power consumption may possibly exceed the limited requirement of the ENERGY STAR® qualification. • Select [Home], the unit is set to maximize the energy efficiency for home setting and it can be adjusted through a choice of picture and sound quality according to your preference. Press Í or Æ to select [Start], then press OK to begin [Settings assistant]. Settings assistant will allow you to customize your picture settings to your personal preference. You will see a series of test pictures where the right side and left side differ. Select the side that is most pleasing to you with the Left/Right buttons. Cancel Start EN 11