Philips AZ1574 User manual - Page 17

Troubleshooting - 17

Page 17 highlights

English TROUBLESHOOTING If a fault occurs, first check the points listed below before taking the set for repair. If you are unable to remedy a problem by following these hints, consult your dealer or service center. WARNING: Do not open the set as there is a risk of electric shock. Under no circumstances should you try to repair the set yourself, as this will invalidate the warranty. PROBLEM - POSSIBLE CAUSE • REMEDY No sound/power - VOLUME not adjusted • Adjust the VOLUME - Headphones connected • Disconnect headphones - Power cord not securely connected • Connect AC power cord properly Severe radio hum or noise - Electrical interference: set too close to TV, VCR or computer • Increase the distance indication - CD-R(W) is blank or the disc is not finalized • Use a finalised CD-R(W) The CD skips tracks - CD damaged or dirty • Replace or clean CD - SHUFFLE or PROGRAM is active • Switch off SHUFFLE / PROGRAM Poor cassette sound quality - Dust and dirt on the heads, etc. • Clean deck parts, see Maintenance - Use of incompatible cassette types (METAL or CHROME) • Only use NORMAL (IEC I) for recording Poor radio reception - Weak radio signal • FM: Direct the FM telescopic antenna for optimum reception Recording does not work - Cassette tab(s) may be broken • Apply a piece of adhesive tape over the missing tab space. indication - CD badly scratched or dirty • Replace/ clean CD, see Maintenance - Laser lens steamed up • Wait until lens has cleared Remote control does not function properly - Batteries dead • Insert fresh batteries - Batteries incorrectly inserted • Insert the batteries correctly - Distance/ angle between the set too large • Reduce the distance/ angle Environmental information All unnecessary packaging material has been omitted. We have done our utmost to make the packaging easy to separate into three mono-materials: cardboard (box), expandable polystyrene (buffer), polyethylene (bags, protective foam). Your set consists of materials which can be recycled if disassembled by a specialized company. Please observe the local regulations regarding the disposal of packing materials, dead batteries and old equipment. 17

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17

TROUBLESHOOTING
17
PROBLEM
– POSSIBLE CAUSE
• REMEDY
No sound/power
VOLUME not adjusted
• Adjust the VOLUME
Headphones connected
• Disconnect headphones
Power cord not securely connected
• Connect AC power cord properly
Severe radio hum or noise
Electrical interference: set too close to TV,
VCR or computer
• Increase the distance
Poor radio reception
Weak radio signal
• FM: Direct the FM telescopic antenna for
optimum reception
indication
CD badly scratched or dirty
• Replace/ clean CD, see Maintenance
Laser lens steamed up
• Wait until lens has cleared
indication
CD-R(W) is blank or the disc is not finalized
• Use a finalised CD-R(W)
The CD skips tracks
CD damaged or dirty
• Replace or clean CD
SHUFFLE or PROGRAM is active
• Switch off SHUFFLE / PROGRAM
Poor cassette sound quality
Dust and dirt on the heads, etc.
• Clean deck parts, see Maintenance
Use of incompatible cassette types
(METAL or CHROME)
• Only use NORMAL (IEC I) for recording
Recording does not work
Cassette tab(s) may be broken
• Apply a piece of adhesive tape over the
missing tab space.
Remote control does not function properly
Batteries dead
• Insert fresh batteries
Batteries incorrectly inserted
• Insert the batteries correctly
Distance/ angle between the set too large
• Reduce the distance/ angle
If a fault occurs, first check the points listed below before taking the set for repair.
If you are unable to remedy a problem by following these hints, consult your dealer or service center.
WARNING:
Do not open the set as there is a risk of electric shock. Under no
circumstances should you try to repair the set yourself, as this will
invalidate the warranty.
Environmental information
All unnecessary packaging material has been omitted. We have done our utmost to make the
packaging easy to separate into three mono-materials: cardboard (box), expandable polystyrene
(buffer), polyethylene (bags, protective foam).
Your set consists of materials which can be recycled if disassembled by a specialized
company. Please observe the local regulations regarding the disposal of packing
materials, dead batteries and old equipment.
English