Philips AZ2055 User manual - Page 8

English CONTROLS TOP AND FRONT PANELS BACK PANEL (See 1) &Telescopic antenna - improves FM reception 1SOURCE - selects CD/ TUNER / TAPE function *Battery compartment - for 6 batteries, 2y - power on/ off switch type R-20, UM1 or D-cells 3Display - shows the status of the set (p - 3.5 mm stereo headphone jack 4Cassette recorder keys Note: The speakers will be muted when RECORD 0 - starts recording headphones are connected to the set. PLAY 2 - starts playback )AC MAINS - inlet for power cord SEARCH 5/6 - fast winds/rewinds tape STOP/OPEN 9/ REMOTE CONTROL (for AZ2055 only) - opens the cassette compartment 1VOLUME 3,4 - adjusts volume level (up, down) - stops the tape PAUSE ; - pauses playback or recording 2SHUFFLE - plays all CD tracks in random order 32; - starts/ pauses CD playback 5BASS, MID, HIGH - EQ keys to adjust the bass, 4SEARCH 5, 6 - searches backwards/ forwards mid & treble frequencies within a track 6PROG 5PRESET +, - - selects a preset radio station CD: programs tracks and reviews the program; (up, down) Tuner: programs preset radio stations 6TUNING ∞, § - tunes to tuner stations Navigation controls 7∞, § (down, up) 79 - stops CD playback; CD: - searches back and forward within a - erases a CD program track; 8¡, ™ - skips to the beginning of a current track - skips to the beginning of a current previous/ subsequent track track/previous/ later track 9REPEAT - repeats a track /program/ entire CD Tuner: - tunes to radio stations (down, up). 82; - starts or pauses CD playback 99 - stops CD playback; CAUTION Use of controls or adjustments or performance of - erases a CD program procedures other than herein may result in hazardous 0MODE - selects different play modes: radiation exposure or other unsafe operation. e.g. REPEAT or SHUFFLE (random) order !PUSH TO OPEN - opens/closes the CD door POWER SUPPLY @VOLUME - to adjust volume level #REMOTE SENSOR (for AZ2055 model only) - infrared sensor for remote control $PRESET DOWN/ UP (-, +) - selects a preset tuner station (down, up) Whenever convenient, use the power supply to conserve battery life. Make sure you remove the power plug from the set and wall outlet before inserting batteries. %BAND - selects waveband ^DBB - (Dynamic Bass Boost) activates a more vivid bass response BASIC FUNCTIONS DIGITAL TUNER Batteries (not included) • Insert 6 batteries, type R-20, UM-1 or D-cells, (preferably alkaline) with the correct polarity. BASIC FUNCTIONS Switching on and off and selecting function 1 Press y on the set to switch on. Remote control (for AZ2055 only /See A) • Insert 2 batteries, type AAA, R03 or UM4 (preferably alkaline). 2 Press SOURCE once or more to select: CD, TUNER or TAPE function. 3 Press y to switch off the set. Notes: - To change from TAPE to TUNER or CD function, or Incorrect use of batteries can cause electrolyte when you are switching off the set: first, make leakage and will corrode the compartment or cause sure you press the tape STOP 9 key to end the batteries to burst. playback and all the cassette keys are released. • Do not mix battery types: e.g. alkaline with carbon - The tone, sound settings, tuner presets and the zinc. Only use batteries of the same type for the volume level (up to a maximum volume level of 20) set. will be retained in the set's memory. • When inserting new batteries, do not try to mix old batteries with the new ones. • Batteries contain chemical substances, so they should be disposed of properly. Adjusting volume and sound 1 Adjust the volume with the VOLUME control. ™ Display shows the volume level and a number Using AC Power 1 Check if the power supply, as shown on the type plate located on the bottom of the set, corresponds to your local power supply. If it does not, consult your dealer or service center. 2 If your set is equipped with a voltage selector, adjust the selector so that it matches with the local power . 3 Connect the power cord to the wall outlet. 4 To disconnect the power supply, unplug the set from the wall outlet. from 0-32. (See 2) 2 Press DBB once or more to select dynamic bass boost on or off. ™ Display: shows when activated. 3 To adjust the bass, mid and treble tones, press and hold + or - on the BASS, MID, HIGH keys until you reach the desired level, -5 to +5 ™ Display briefly shows BASS, MID, or HIGH and the level. (See 3) Note: To prevent sound interference the bass control options operate exclusively. You cannot combine the bass from BASS with DBB Auto-Standby mode When a CD or tape has reached the end of playback and remains in the stop position for more than ™ The display shows or the indicator is automatically switched off to remind you if you attempt to use both bass settings. 15 minutes, the set will switch off automatically to save energy. The type plate is located on the bottom of the set.