Philips DCM276 User manual - Page 12

1 Open the battery compartment. 2 Insert 2 AAA batteries with correct polarity (+/-) as indicated. 3 Close the battery compartment. Note ‡ If you are not going to use the remote control for a long time, remove the batteries. ‡ Do not use old and new or different types of batteries in combination. ‡ Batteries contain chemical substances, so they should be disposed of properly. Connect power Caution ‡ Risk of product damage! Ensure that the power supply voltage corresponds to the voltage printed on the bottom of the unit. ‡ Before connecting the AC cord, ensure you have completed all other connections. Note ‡ The type plate is located on the rear of the main unit. 1 Connect the AC cord to the AC outlet. Auto install radio stations When you connect power and no radio stations are stored, the unit automatically begins to store radio stations. 1 Connect the unit to the power supply. » [AUTO INSTALL - PRESS PLAY KEY] (auto install - press play key) is displayed. 2 Press on the main unit to start installation. » The unit automatically stores radio VWDWLRQVZLWKVXIÀFLHQWVLJQDOVWUHQJWK » When all the available radio stations DUHVWRUHGWKHÀUVWSUHVHWUDGLRVWDWLRQ is broadcast automatically. Set clock Note ‡ You can set the clock in the standby mode only. 1 Press PROG/CLOCK SET to enter the clock setting mode. » [SET CLOCK] (set clock) scrolls on the screen. 2 Press / repeatedly to select 12 hour or 24 hour format. 3 Press PROG/CLOCK SETWRFRQÀUP » The hour digits are displayed and begin to blink. 4 Press / to set the hour. 5 Press PROG/CLOCK SETWRFRQÀUP » The minute digits are displayed and begin to blink. 6 Press / to set the minute. 7 Press PROG/CLOCK SETWRFRQÀUPWKH clock setting. 12 EN