Philips DCP951 User manual - Page 12

English PREPARATIONS Power supply Using the AC / DC adaptor Connect the supplied adapter to the set and the main power supply (as shown). ✔ TIP To avoid damage to the player, switch off before plugging or unplugging the AC adaptor. Using the car adapter Connect the supplied car adapter to the set and the car cigarette lighter outlet. ✔ TIP • To avoid damage to the player, switch off before plug- ging or unplugging the car adaptor. • When connecting with car power (cigarette lighter) adaptor, be sure the • Minpauktevsoultraegteheoftethmepeardaatputroeriissbideelonwtic3a5lowCitwhhceanr voltage. the DVD player is con- nected to DC 16.0V in a car. Powering your remote control 1 Open the battery compartment. Remove the protective plastic tab (first time users only). 2 Insert 1 x lithium 3V battery, type CR2025, then close the compartment. CAUTION - Batteries contain chemical substances, so they should be disposed of properly. - Danger of explosion if battery is incorrectly replaced. Replace only with the same or equivalent type. - Incorrect use of batteries can cause electrolyte leakage and will corrode the compartment or cause the batteries to burst. 12 PREPARATIONS - Remove the battery if the remote control is not to be used for a long time. - Perchlorate Material-special handling may apply. See www.dtsc.ca.gov/hazardouswaste/perchlorate. Connections Connecting headphones Connect the headphones into the n1 or the n2 jack of your set. Connecting additional equipment • Turn off your set before connecting to any addi- tional equipment. • You can connect the player to a TV or an amplifier to enjoy DVDs or karaoke. AV OUT Connect the desired device to this terminal directly (no setting needed in the DVD, iPod or SD/MMC mode). White Red Yellow AV IN On the DVD player panel, press the source key repeatedly (AV on the remote) to select AV IN (AUX). White Red Yellow Connection Color Video Yellow Audio (Left) White Audio (Right) Red