Philips DVD701AT User manual - Page 16
Connecting the power cord, Remote control battery installation, NTSC/PAL Settings
View all Philips DVD701AT manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 16 highlights
+ + - Connecting the power cord 1 Plug the female end of the supplied power cord into the Mains (AC) jack on the rear of the player. 2 Connect the other end of the cord to an AC outlet. Note: When the player is in the "STANDBY" mode, it is still consuming some power. If you wish to disconnect your player completely from the power, press POWER ON/OFF Caution: Only qualified service personnel should remove the cover or attempt to service this device. Remote control battery installation Loading the batteries 1 Open the battery compartment cover. 2 Insert batteries as indicated inside the battery compartment. 3 Close the cover. Caution: Do not mix old and new batteries. Never mix different types of batteries (standard, alkaline, etc.). NTSC/PAL Settings You can switch the NTSC/PAL setting of the DVD player to match the video signal of your TV.This setting only affects the television's on-screen display that shows the stop and setup modes.You may select either NTSC or PAL.To change the DVD player setting to PAL or NTSC, follow the steps below. 1 Press the POWER ON/OFF button on the front panel of the DVD player to turn OFF the DVD player. 2 Press and hold / and T on the front of the DVD player.While holding / and T, press POWER ON/OFF. 3 After PAL or NTSC appears on the display panel of the DVD player, release / and T at the same time.The PAL or NTSC that appears on the display panel indicates the current setting. 4 To change the setting, press T within three seconds.The new setting (PAL or NTSC) will appear on the display panel. 16 PREPARATION