Philips HF3470 User manual - Page 10
Problem, Solution - light
UPC - 075020012142
View all Philips HF3470 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 10 highlights
16 English Problem Solution The appliance does not respond when I try to set different functions. Remove the plug from the wall outlet and reinsert it. If you reinsert the plug within approximately 15 minutes, the appliance remembers all settings. If you reinsert the plug after a longer period of time, the appliance will go back to factory settings.You need to set all functions again. The lamp does not go Perhaps you set a light intensity level that is too low. Increase the light on when the alarm goes intensity level. off. Perhaps you switched off the alarm by setting the control lever to the top position.To switch on the alarm, set the control lever to the middle position. The lamp does not go on right away when I switch it on. It takes approx. 1 second for the lamp to go on.This is normal, the lamp needs to heat up. I do not hear the alarm Perhaps you set a sound level that is too low.To set a higher sound sound when the alarm level, see chapter 'Using the appliance', section 'Radio/volume'. goes off. Perhaps you switched off the alarm by setting the control lever to the top position. Switch on the radio after you switch off the alarm to check if the radio works. If it does not work, call 1-866-832-4361 for assistance. The radio does not work. Call 1-866-832-4361 for assistance. The radio produces a crackling sound. Perhaps the broadcast signal is weak. Adjust the frequency (see chapter 'Using the appliance' section 'Radio/volume') and/or change the position of the antenna by moving it around. Make sure you have unwound the antenna completely. The alarm went off Perhaps you switched off the alarm by setting the control lever to the yesterday, but it did not top position. go off today. Perhaps you set a sound level and/or light intensity level that is too low. Set a higher sound and/or light intensity level. Perhaps there was a power failure that lasted more than approximately 15 minutes. In this case the appliance goes back to factory settings.You need to set all functions again. The alarm did not go off 9 minutes after I pushed the control lever down to snooze. Perhaps you pushed the control lever down with so much force that it jumped to off position. Perhaps you set the volume level to OFF. The light wakes me too Perhaps the light intensity level you have set is not appropriate for you. early. Try a lower light intensity level if you wake up too early. If light intensity 1 is not low enough, move the appliance further away from the bed. English 17 Problem The light wakes me too late. Solution Perhaps the appliance is positioned at a lower level than your head. Make sure the appliance is located at a height at which the light is not blocked by your bed, comforter/blanket or pillow. Also make sure the appliance is not placed too far away. Perhaps the appliance is not suitable for the voltage to which it is connected. Make sure that the voltage indicated on the appliance corresponds to the local voltage.