Philips MC-i200 User manual - Page 33

Clock/Timer English IMPORTANT! When in Eco Power standby mode, it is not possible to operate the clock or timer function. View clock The clock (if it is set) will be shown in standby mode. To view the clock in any source mode (CD or TUNER for example) q Press CLK/TIMER on the remote control. ➜ The clock is displayed for a few seconds. ➜ If the clock has not been set, "--:--" is displayed. Clock setting The clock can be set in either 12-hour or 24-hour mode ("12:00 AM" or "00:00", for example). 1 In standby or view clock mode, press CLK/TIMER once. In any other source modes, press CLK / TIMER twice. ➜ "12:00 AM" or "00:00" starts flashing. 2 Press the left hand soft key (@) to select 12- or 24- hour clock mode. 3 Press S or T (or ¡ / ™ on the remote control) to switch between hour or minutes setting. ➜ The hour or minutes digits flash. 4 Use the navigation jog (or press 3 / 4 on the remote control) to set the hour and minutes. 5 Press CLK/TIMER again to store the setting. ➜ The clock starts working. To exit without storing the setting q Press Ç. Notes: - The clock setting will be cancelled when the power cord is disconnected or if a power failure occurs. - During clock setting, if no button is pressed within 90 seconds, the system will exit clock setting mode automatically. Timer setting The system can switch on to CD, TUNER, INTERNET or PC LINK mode automatically at a preset time, serving as an alarm to wake you up. IMPORTANT! - Before setting the timer, ensure that the clock is set correctly. - The timer will always be switched on after it has been set. - The volume of the timer will increase gradually from the minimum level to the last tuned volume level. - The system will switch to standby mode if no button is pressed within 30 minutes after timer wake up. 31