Philips MCD908 User manual - Page 20

English Getting Started Step 1: Inserting batteries into the Remote Control 3 1 2 1 Open the battery compartment. 2 Insert two AAA batteries following the indications (+/-) inside the compartment. 3 Close the cover. Using the Remote Control to operate the Player 1 Aim the Remote Control directly at the remote sensor (IR) on the front panel. 2 Do not put any objects between the Remote Control and the DVD Player while operating the DVD Player. CAUTION! - Remove batteries if they are exhausted or if the Remote Control is not being used for a long time. - Do not use old and new or different types of batteries in combination. - Batteries contain chemical substances, so they should be disposed of properly. Step 2: Setting up the TV IMPORTANT! Make sure you have completed all the necessary connections. (See "Connecting TV"). 1 Switch the DVD system on and then select DISC source. (See "Switching the system on/off"). 2 Turn on the TV and set to the correct video-in channel.You should see the blue Philips DVD background screen on the TV. ➜ Usually these channels are between the lowest and highest channels and may be called FRONT, A/V IN, or VIDEO. See your TV manual for more details. ➜ Or, you may go to channel 1 on your TV, then press the Channel down button repeatedly until you see the Video In channel. ➜ Or, the TV Remote Control may have a button or switch that chooses different video modes. ➜ Or, set the TV to channel 3 or 4 if you are using an RF modulator. Selecting the colour system that corresponds to your TV This DVD Player is compatible with both NTSC and PAL. In order for a DVD disc to play on this Player, the colour system of the Disc, the TV and the DVD Player should match. 1 Press SYSTEM in full stop mode. 2 Press 1 2 to select "PREFERENCE PAGE". 3 Use 1 2 3 4 on the remote to navigate in the menu. Move to "TV TYPE" and press 2. ➜ PAL: Select this if the connected TV is PAL system. It will change the video signal of a NTSC disc and output in PAL format. ➜ Auto: Select this if the connected TV is compatible with both NTSC and PAL (multisystem).The output format will be in accordance with the video signal of the disc. ➜ NTSC: Select this if the connected TV is NTSC system. It will change the video signal of a PAL disc and output in NTSC format. 4 Select an item and press OK. Notes: - This option is available only when the "HDMI" is set to "OFF". - Before changing the current TV Type setting, ensure that your TV supports the selected TV Type. 20