Pioneer 434CMX Service Manual - Page 111
DISASSEMBLY, Rear Case 43M, Front Case 434 CMX - pdp 43 inch
UPC - 012562691107
View all Pioneer 434CMX manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 111 highlights
5 6 7 8 7.1.8 DISASSEMBLY 1 Rear Case (43M), Front Case 434 (CMX) 1 Remove the grip by removing the four screws. 2 Remove the six screws. Rear case (43M) 3 3 3 3 A 3 Remove the sixteen screws. 2 2 Note : 3 3 When reattaching the rear case (43M), first attach 1 1 the screws for the holes indicated with ∗1 to place the rear case (43M) in the correct position. 4 Remove the rear case (43M). Grip 1 23 ∗1 4 32 Grip ∗1 1 3 3 3 Note: 2 • When reattaching the grip, be sure to securely tighten the screws. • An installation direction of the grip of PDP- 33 3 434CMX/ PDP-43MXE1 and PDP-43MXE1-S (43-inch) is different from PDP-504CMX/ PDP- 50-inch 43-inch 50MXE1 and PDP-50MXE1-S (50-inch). (Refer to the right figure.) 2 B 33 43-inch 50-inch Inner side Inner side Inner side Inner side 5 Remove the three screws. 6 Remove the one rivet. 7 Remove the lead cover (4G). 8 Disconnect the flexible cable. 9 Remove the front case 434 (CMX). Grip attachment position Grip attachment position C Note: If only the front case must be removed, without removing the rear case, perform the steps 5 to 9. First pull the lower part of the front case 434 (CMX) out toward you then lift the case up. D 9 Front case 434 (CMX) 5 ×3 KEY CONTROL Assy E 6 48 Lead cover (4G) Rivet 7 Turn it not to press the rivet. (Because when the rivet presses, fit in once again.) Lead cover (4G) F PDP-434CMX 111 5 6 7 8