Pioneer 434CMX Service Manual - Page 153
installation bracket, Installation using accessories other than the PIONEER
UPC - 012562691107
View all Pioneer 434CMX manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 153 highlights
5 6 7 8 Installation using the optional PIONEER stand or Wall-mount installation of the unit installation bracket This unit has been designed with bolt holes for ÷ Please be sure to request installation or mounting of this wall-mount installation, etc.. The installation holes that can unit or the installation bracket by an installation be used are shown in the diagram below. A specialist or the dealer where purchased. ÷ When installing, be sure to use the bolts provided with ÷ Be sure to attach in 4 or more locations above and the stand or installation bracket. below, left and right of the center line. ÷ For details concerning installation, please refer to the ÷ Use bolts that are long enough to be inserted 1/2 inch instruction manual provided with the stand or installation (12 mm) to 11/16 inch (18 mm) into the main unit from bracket. the attaching surface for both a holes and b holes. Refer to the side view diagram below. Installation using accessories other than the PIONEER ÷ As this unit is constructed with glass, be sure to install it stand or installation bracket (sold separately) on a flat, unwarped surface. ÷ When possible, please install using parts and accessories manufactured by PIONEER. PIONEER will not he held responsible for accident or damage caused B by the use of parts and accessories manufactured by other companies. ÷ For custom installation, please consult the dealer where the unit was purchased, or a qualified installer. b hole Air vents (fan) a hole a hole Center line Rear view diagram Main unit Center line b hole C Attaching surface Installation bracket,etc.. a hole Bolt 1/2 inches (12 mm) to D 11/16 inches (18 mm) Bolt b hole 1/2 inches (12 mm) to 11/16 inches (18 mm) Side view diagram E CAUTION CAUTION To avoid malfunction, overheating of this unit, and possible This display unit weighs at least 32.5 kg (71 lbs 10oz) and fire hazard, make sure that the vents on the main unit are has little front to back depth, making it very unstable when not blocked when installing. Also, as hot air is expelled stood on edge. As a result, two or more persons should from the air vents, be careful of deterioration and dirt build cooperate when unpacking,moving, or installing the display. up on rear surface wall, etc.. CAUTION CAUTION This unit incorporates a thin design. To ensure safety if Please be sure to use an M8 (Pitch = 1.25 mm) bolt. (Only vibrated or shaken, please be sure to take measures to this size bolt can be used.) prevent the unit from tipping over. F PDP-434CMX 153 5 6 7 8