Pioneer AVH-P4900DVD Other Manual - Page 2

Connecting the Units Connecting the power cord 15 cm (5-7/8 in.) Antenna cable IP-BUS input (Blue) Multi-CD player (sold separately) IP-BUS cable This product Yellow/black If you use an equipment with Mute function, wire this lead to the Audio Mute lead on that equipment. If not, keep the Audio Mute lead free of any connections. Red Connect to terminal controlled by ignition switch (12 V DC). Fuse resistor Violet/white Of the two lead wires connected to the back lamp, connect the one in which the voltage changes when the gear shift is in the REVERSE (R) position. For details, see Fig. 4 Yellow Fuse holder (10 A) Connect to the constant 12 V supply terminal. Black (chassis ground) Connect to a clean, paint-free metal location. + Front speaker White Gray + ≠ ≠ Left White/black Gray/black Green Violet Rear speaker + + ≠ ≠ Green/black Violet/black 15 cm (5-7/8 in.) Connection method 1. Clamp the lead. WARNING Note: • The position of the parking brake switch depends on the vehicle model. For details, consult the vehicle Owner's Manual or dealer. LIGHT GREEN LEAD AT POWER CONNECTOR IS DESIGNED TO DETECT PARKED STATUS AND MUST BE CONNECTED TO THE POWER SUPPLY SIDE OF THE PARKING BRAKE SWITCH. IMPROPER CONNECTION OR USE OF THIS LEAD MAY VIOLATE APPLICABLE LAW AND MAY RESULT IN SERIOUS INJURY OR DAMAGE. Light green Used to detect the ON/OFF status of the parking brake. This lead must be connected to the power supply side of the parking brake switch. Power supply side Ground side Front speaker Right Rear speaker Blue/white Connect to system control terminal of the power amp or auto-antenna relay control terminal (max. 300 mA 12 V DC). With a 2 speaker system, do not connect anything to the speaker leads that are not connected to speakers. When you connect separately sold multi-channel processor (DEQ-P8000) to this unit, do not connect anything to the speaker leads and system remote control (blue/white). 2. Clamp firmly with needle-nosed pliers. Parking brake switch Fig. 2 When connecting to separately sold power amp Subwoofer output or non fading output (SUBWOOFER OUTPUT or NON-FADING OUTPUT) 23 cm (9 in.) This product 15 cm (5-7/8 in.) Rear output (REAR OUTPUT) Front output (FRONT OUTPUT) 15 cm (5-7/8 in.) Blue/white Connect to system control terminal of the power amp (max. 300 mA 12 V DC). When you connect separately sold multi-channel processor (e.g. DEQ-P8000) to this unit, do not connect anything to the speaker leads and system remote control (blue/white). Note: When you connect multi-channel processor to this unit, separately sold power amp must be connected to multi-channel processor. Note: Change the initial setting of this product (refer to the Operation Manual). The subwoofer output of this unit is monaural. RCA cables (sold separately) Power amp (sold separately) Power amp (sold separately) Power amp (sold separately) System remote control Left + Front speaker ≠ + Rear speaker ≠ Right + Front speaker ≠ + Rear speaker ≠ + Subwoofer ≠ + Subwoofer ≠ Perform these connections when using the optional amplifier. Fig. 3