Pioneer AVH-X7800BT Owner s Manual - Page 50
Connection - installation manual
View all Pioneer AVH-X7800BT manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 50 highlights
Connection The black cable is ground. When installing this unit or power amp (sold separately), make sure to connect the ground wire first. Ensure that the ground wire is properly connected to metal parts of the car's body. The ground wire of the power amp and the one of this unit or any other device must be connected to the car separately with different screws. If the screw for the ground wire loosens or falls out, it could result in fire generation of smoke or malfunction. Ground wire POWER AMP Notice for the blue/white lead When the ignition switch is turned on (ACC ON), a control signal is output through the blue/white lead. Connect to an external power amp's system remote control terminal, the auto-antenna relay control terminal, or the antenna booster power control terminal (max. 300 mA 12 V DC). The control signal is output through the blue/white lead, even if the audio source is switched off. This product 1 2 3 Power cord 1 2 3 4 5 6 7 8 9 a Other devices Metal parts of car's body (Another electronic device in the car) 45 c b d When replacing the fuse, be sure to only use a fuse of the rating prescribed on this product. This product cannot be installed in a vehicle without ACC (accessory) position on the ignition switch. F ACC O F O OF OF N STAR N STAR T T ACC position No ACC position To avoid short-circuiting, cover the disconnected lead with insulating tape. It is especially important to insulate all unused speaker leads, which if left uncovered may cause a short circuit. For connecting a power amp or other devices to this product, refer to the manual for the product to be connected. 50 8 76 9 a b 1 Pioneer navigation system Please contact your dealer to inquire about the connectable navigation unit. 2 RGB cable(supplied with Navigation system) 3 Microphone 4 m (13 ft. 1 in.) (AVH-X7800BT) 4 This product 5 Antenna jack 6 Power supply 7 Fuse (10 A) 8 Wired remote input Hard-wired remote control adapter can be connected (sold separately). 9 Front output (STD)/High range output (NW) a Rear output (STD)/Middle range output (NW) b SubWoofer output (STD)/Low range output (NW) 1 To power supply 2 Power cord 3 Yellow To terminal supplied with power regardless of ignition switch position. 4 Red To electric terminal controlled by ignition switch (12 V DC) ON/OFF. 5 Orange/white To lighting switch terminal. 6 Black (ground) To vehicle (metal) body. 7 Violet/white Of the two lead wires connected to the back lamp, connect the one in which the voltage changes when the gear shift is in the REVERSE (R) position. This connection enables the unit to sense whether the car is moving forwards or backwards. 8 Yellow/black If you use an equipment with Mute function, wire this lead to the Audio Mute lead on that equipment. If not, keep the Audio Mute lead free of any connections.