Pioneer AVIC N1 Owner's Manual - Page 110

NAVI/AV Message Direction of G sensor is not correct. Please power off the system and check the installation. After you have checked, please re-boot the system and press "OK". Sensor NG (BAD) angle Gyro Sensor is not working properly. Please consult your dealer or Pioneer service center. The route could not avoid the specified area. Your route could not be found. Route calculation was not possible. Route calculation was not possible because the destination is too far. Route calculation was not possible because the destination is too near. Route calculation was not possible due to traffic regulations. Route calculation was not possible because no guidance can be provided around the destination or the starting point. There is no route to the destination. The maximum number of registrations has been completed. Please clear existing registered items and re-register current item. Memory is full. Irregular character strings. Please input again. An error has occurred. Please note the following error code and switch power off. When Direction of G sensor is set incorrectly. The navigation unit is installed with an extreme angle exceeding the limitation of the installation angle. Abnormal output of Gyrosensor is detected. If route setting cannot avoid specified Areas to Avoid. Route calculation has failed because of malfunction of map data, software, hardware, or disc. Route calculation has failed because of malfunction of map data, software, hardware, or disc. The destination is too far. The destination or way point(s) is too close. •The destination or way point(s) are in a Control Traffic Zone (CTR) and the route calculation is hampered. •Your vehicle is currently in a Control Traffic Zone (CTR) and the route calculation is hampered. The destination, way point(s), or starting point are in an area where no road exists (e.g. a mountain) and the route calculation is impossible. The destination or way point(s) are in an isolated island, etc. without a ferry and the route calculation is impossible. If there are already 300 items when you attempt to register an item in the Address Book. When the total 300 resistered points are in the CD-R and Address Book, you attempt moving an item to the Address Book from CD-R. A symbol that cannot be pronounced was entered. In the case of a system failure. What to do See the "Installation Manual" and set the direction of the Hide-away unit correctly. Confirm the installation angle. (The navigation system must be installed within +30 degrees to -30 degrees of the horizontal, or within five degrees of your vehicle's direction of travel.) Note down the error code shown on the screen; turn off the power, and then contact your nearest Pioneer service facility. Choose whether or not to try setting a route through the area. •Change the destination. •Clean the disc. •Consult the Pioneer Local dealer if this message persists. •Change the destination. •Clean the disc. •Consult the Pioneer Local dealer if this message persists. • Set a destination closer to the starting point. • Set one or more way points. Set a destination [and way point(s)] farther from the starting point. •Set a destination and way point(s) outside the CTR if you know where the restricted area is. •Try the destination or way point(s) away from the currently set points to some extent. •Drive your vehicle to an unrestricted area and reset the destination and way point(s). •Set a destination and way point(s) on roads. •Reset the destination after you drive the vehicle to any road. Change the destination. Delete some destinations as appropriate. Delete unnecessary data and try to register again. Enter a word that can be pronounced. Note down the error code shown on the screen; turn off the power, and then contact your nearest Pioneer service facility. Appendix 108