Pioneer AVICF500BT Owner's Manual - Page 107
Appendix - av receiver
UPC - 012562896281
View all Pioneer AVICF500BT manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 107 highlights
Appendix Appendix Appendix The map color does not switch automatically between daytime and nighttime. [Night mode] is set to [Day]. Check [Night mode] setting and make sure [Automatic] is selected. (Page 81) The screen is too bright. An improper value has been set on Check the settings. "Brightness". The display is very dim. [Night] is selected in "Night mode". Check the setting of [Night mode] and select [Automatic] or [Day]. (Page 81) An improper value has been set on Check the settings. "Brightness". No sounds of AV source are pro- The volume level is low. duced. The volume level will not rise. A speaker lead is disconnected. Adjust the volume level. Check the connection. Adjusting the volume of naviga- You cannot adjust these with tion guidance and beeps is not MULTI-CONTROL. possible. Turn the volume up or down according to [Sound settings] on the "Navi Settings" menu. (Page 86) The person on the other end of the phone call cannot hear the conversation due to an echo. The voice from the person on the Use the following methods to reduce the other end of the phone call is output echo: from the speakers and then picked -Lower the volume on the receiver up by the microphone again, creat- -Have both speakers pause slightly before ing an echo. speaking There's no picture while this pro- The parking brake cord is not con- Connect the parking brake cord, and apply duct is attached on the cradle. nected. the parking brake. The parking brake is not applied. Connect the parking brake cord, and apply the parking brake. The backlight of the LCD panel is turned off. Turn on the backlight. (Page 95) Nothing is displayed and the touch panel keys cannot be used. The setting for the rear view camera Select the appropriate setting for the rear is incorrect. view camera. The shift lever was placed in [R] when the rear view camera was not connected. Press MAP button, and then press MENU button to return to the "Top Menu" and then select the correct polarity setting for [Back Camera]. (Page 92) There is no response when the The touch panel keys deviate from Perform the touch panel calibration. (Page touch panel key are touched or the actual positions that respond to 93) a different key responds. your touch for some reason. Problems in the AV screen Symptom Cause Action (See) The screen is covered with the caution message and the video cannot be shown. The parking brake lead is not connected or applied. The parking brake interlock is activated. Connect the parking brake lead correctly, and apply the parking brake. Park your vehicle in a safe place and apply the parking brake. No video output from connected [AV Input] setting is incorrect. Establish the setting correctly. (Page 78) equipments. The connection of the USB interface Connect both USB plug and mini-jack cable No video output from connected cable for iPod is incorrect. side. (If only one connection has made, an iPod. iPod will not work properly.) (Page 14) En 107