Pioneer AVICF500BT Owner's Manual - Page 121

Using the LCD screen correctly, Appendix

Page 121 highlights

Appendix Appendix Appendix ! Firmly secure the iPod when driving. Do not let the iPod fall onto the floor, where it may become jammed under the brake or gas pedal. For details, refer to the iPod's manuals. Using the LCD screen correctly Handling the LCD screen ! When the LCD screen is subjected to direct sunlight for a long period of time, it will become very hot, resulting in possible damage to the LCD screen. When not using this navigation system, avoid exposing it to direct sunlight as much as possible. ! The LCD screen should be used within the temperature ranges shown in "Specifications". ! Do not use the LCD screen at temperatures higher or lower than the operating temperature range because the LCD screen may not operate normally and the LCD screen can be damaged. ! The LCD screen is exposed in order to increase its visibility within the vehicle. Please do not press strongly on it as this may damage it. ! Do not push the LCD screen with excessive force as this may scratch it. ! To protect the LCD screen from damage, be sure to touch the touch panel keys only with your fingers. (Keep the use of other instruments at a minimum, and only in cases in which the touch panel calibration is necessary.) Liquid crystal display (LCD) screen ! If the LCD screen is near the vent of an air conditioner, make sure that air from the air conditioner is not blowing on it. Heat from the heater may break the LCD screen, and cool air from the cooler may cause moisture to form inside the navigation unit, resulting in possible damage. ! Small black dots or white dots (bright dots) may appear on the LCD screen. These are due to the characteristics of the LCD screen and do not indicate a problem with the LCD screen. ! The LCD screen will be difficult to see if it is exposed to direct sunlight. ! When using a cellular phone, keep the antenna of the cellular phone away from the LCD screen to prevent disruption of the video in the form of disturbances such as spots or colored stripes. Maintaining the LCD screen ! When removing dust from the LCD screen or cleaning it, first turn the system power off, then wipe with a soft dry cloth. ! When wiping the LCD screen, take care not to scratch the surface. Do not use harsh or abrasive chemical cleaners. LED (light-emitting diode) backlight A light emitting diode is used inside the display to illuminate the LCD screen. ! At low temperatures, using the LED back- light may increase image lag and degrade the image quality because of the characteristics of the LCD screen. Image quality will improve with an increase in temperature. ! The product lifetime of the LED backlight is more than 10 000 hours. However, it may decrease if used in high temperatures. ! If the LED backlight reaches the end of its product lifetime, the screen will become dark and the image will no longer be projected. In this case, please consult your dealer or the nearest authorized PIONEER Service Station. En 121

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
  • 54
  • 55
  • 56
  • 57
  • 58
  • 59
  • 60
  • 61
  • 62
  • 63
  • 64
  • 65
  • 66
  • 67
  • 68
  • 69
  • 70
  • 71
  • 72
  • 73
  • 74
  • 75
  • 76
  • 77
  • 78
  • 79
  • 80
  • 81
  • 82
  • 83
  • 84
  • 85
  • 86
  • 87
  • 88
  • 89
  • 90
  • 91
  • 92
  • 93
  • 94
  • 95
  • 96
  • 97
  • 98
  • 99
  • 100
  • 101
  • 102
  • 103
  • 104
  • 105
  • 106
  • 107
  • 108
  • 109
  • 110
  • 111
  • 112
  • 113
  • 114
  • 115
  • 116
  • 117
  • 118
  • 119
  • 120
  • 121
  • 122
  • 123
  • 124
  • 125
  • 126
  • 127
  • 128
  • 129

!
Firmly secure the iPod when driving. Do not
let the iPod fall onto the floor, where it may be-
come jammed under the brake or gas pedal.
For details, refer to the iPod
s manuals.
Using the LCD screen correctly
Handling the LCD screen
!
When the LCD screen is subjected to direct
sunlight for a long period of time, it will be-
come very hot, resulting in possible da-
mage to the LCD screen. When not using
this navigation system, avoid exposing it to
direct sunlight as much as possible.
!
The LCD screen should be used within the
temperature ranges shown in
Specifica-
tions
.
!
Do not use the LCD screen at temperatures
higher or lower than the operating tem-
perature range because the LCD screen
may not operate normally and the LCD
screen can be damaged.
!
The LCD screen is exposed in order to in-
crease its visibility within the vehicle.
Please do not press strongly on it as this
may damage it.
!
Do not push the LCD screen with excessive
force as this may scratch it.
!
To protect the LCD screen from damage, be
sure to touch the touch panel keys only
with your fingers. (Keep the use of other in-
struments at a minimum, and only in cases
in which the touch panel calibration is ne-
cessary.)
Liquid crystal display (LCD) screen
!
If the LCD screen is near the vent of an air
conditioner, make sure that air from the air
conditioner is not blowing on it. Heat from
the heater may break the LCD screen, and
cool air from the cooler may cause moist-
ure to form inside the navigation unit, re-
sulting in possible damage.
!
Small black dots or white dots (bright dots)
may appear on the LCD screen. These are
due to the characteristics of the LCD
screen and do not indicate a problem with
the LCD screen.
!
The LCD screen will be difficult to see if it is
exposed to direct sunlight.
!
When using a cellular phone, keep the an-
tenna of the cellular phone away from the
LCD screen to prevent disruption of the
video in the form of disturbances such as
spots or colored stripes.
Maintaining the LCD screen
!
When removing dust from the LCD screen
or cleaning it, first turn the system power
off, then wipe with a soft dry cloth.
!
When wiping the LCD screen, take care not
to scratch the surface. Do not use harsh or
abrasive chemical cleaners.
LED (light-emitting diode)
backlight
A light emitting diode is used inside the dis-
play to illuminate the LCD screen.
!
At low temperatures, using the LED back-
light may increase image lag and degrade
the image quality because of the character-
istics of the LCD screen. Image quality will
improve with an increase in temperature.
!
The product lifetime of the LED backlight is
more than 10 000 hours. However, it may
decrease if used in high temperatures.
!
If the LED backlight reaches the end of its
product lifetime, the screen will become
dark and the image will no longer be pro-
jected. In this case, please consult your
dealer or the nearest authorized PIONEER
Service Station.
Appendix
En
121
Appendix
Appendix