Pioneer BDP-05FD Owner's Manual - Page 52

07 52 En Problem Check Remedy Picture is disturbed during playback. Picture is dark. • This player supports Macrovision analog copy protection technology. With some TVs (such as with built-in video deck), the picture will not be displayed properly when the copy protected DVD title is played. This is not a malfunction. • If the player and TV are connected via a DVD recorder/video deck, etc., the picture will not be displayed properly due to analog copy protection. Connect the player and TV directly. No picture is displayed or picture is not output in high definition when playing BDs. With some content protected discs, it may not be possible to output the video signals from the VIDEO output terminals, the S-VIDEO output terminal or the COMPONENT VIDEO output terminals. In this case, connect using an HDMI cable (page 14). No sound is output. Sound is disturbed. Is the disc played back in slow motion? Is the disc played back in fast forward or fast reverse? No sound is output during slow motion play and forward and reverse scanning. Is the disc scratched? The sound may not be output if the disc is scratched. Is the disc dirty? Clean the disc (page 59). Is the player properly connected to the other components (AV • Check that you connect the player to the audio output receiver or amplifier, etc.)? terminals of a different component, etc. • Check that you connect the player to the PHONO input terminals of the AV receiver or amplifier, etc. Are the connected components (AV receiver or amplifier, etc.) Read the operating instructions of the connected components properly set? and check the volume, input, speaker settings, etc. Are the audio cables properly connected? Insert the cables firmly and all the way in. Is the audio cable damaged? If the cable is damaged, replace it with a new one. Is Audio Output Mode properly set? If Audio Output Mode is set to Multi-channel, the audio signals may not be output properly from the AUDIO OUT (2 ch) terminals (page 40). Set Audio Output Mode to 2 Channel. Are the speakers properly set? Set Speaker Setup properly (page 40). For some BDs, audio signals are only output from the optical digital audio output terminal, the coaxial digital audio output terminal or the HDMI output terminal. Multi-channel sound is not output. Is the AV receiver or amplifier, etc. connected to the HDMI Read the operating instructions of the connected AV receiver OUT terminal, the AUDIO OUT (7.1 ch) terminals or DIGITAL or amplifier and check the audio output settings of AV receiver OUT (COAXIAL/OPTICAL) terminal? or amplifier. Is Output Terminal Priority properly set? Linear PCM (2-channel) audio signals are output from output terminals other than the one set at Audio under Output Terminal Priority. Set Output Terminal Priority properly (page 48). Is the audio output of the connected AV receiver or amplifier, Read the operating instructions of the connected AV receiver etc., properly set? or amplifier and check the audio output settings of AV receiver or amplifier. Is multi-channel sound selected? Use the menu screen or AUDIO to switch the disc's sound to multi-channel. Is Audio Out set to audio formats supported by the connected • Read the operating instructions of the connected AV receiver AV receiver or amplifier? or amplifier and check the supported audio formats. • Set Audio Out properly (page 40). Are Audio Output Mode and Speaker Setup properly set? • When the AV receiver or amplifier, etc., is connected to the AUDIO OUT (7.1 ch) terminals, set Audio Output Mode to Multi-channel (page 40). • Set Speaker Setup properly (page 40). Digital audio signals are not output from the DIGITAL OUT output (COAXIAL/ DIGITAL) terminals (analog audio signals are output). Is Audio Out set to audio formats supported by the connected • Read the operating instructions of the connected AV receiver AV receiver or amplifier? or amplifier and check the supported audio formats. • Set Audio Out properly (page 40). Noise can be heard when outputting DTS Digital Surround signals. Is the connected AV receiver or amplifier compatible with DTS If an AV receiver or amplifier that is not compatible with DTS Digital Surround? Digital Surround is connected to the DIGITAL OUT terminal, set DTS Out to DTS  PCM. Noise will be heard if DTS Out is set to DTS (page 40).