Pioneer DEH-X3700UI Owner's Manual - Page 6

Preparing the remote control, Setting the clock CLOCK SET, Canceling the demonstration display DEMO - installation

Get Pioneer DEH-X3700UI PDF manuals and user guides View all Pioneer DEH-X3700UI manuals
Add to My Manuals
Save this manual to your list of manuals

Page 6 highlights

Preparing the remote control Remove the insulation sheet before use. How to replace the battery Insert the CR2025 (3 V) battery with the plus (+) and minus (-) poles orientated properly. WARNING • Keep the battery out of the reach of children. Should the battery be swallowed, consult a doctor immediately. • Do not expose the battery or remote control to excessive heat such as direct sunlight or fire. CAUTION • There is a potential danger of explosion if the battery is incorrectly replaced. When replacing the battery, replace it with the same type. • Do not handle or store the battery with metallic tools or objects. • If the battery leaks, remove the battery and wipe the remote control completely clean. Then install a new battery. • When disposing of used batteries, compliance with governmental regulations or environmental institutions' rules that apply in your country/area must be followed that pertain to any special handling needed for disposal. • "Perchlorate Material - special handling may apply.  See www.dtsc.ca.gov/hazardouswaste/perchlorate. (Applicable to California, U.S.A.)" Important • Do not store the remote control in high temperatures or direct sunlight. • Do not let the remote control fall onto the floor, where it may become jammed under the brake or accelerator pedal. Setting the clock (CLOCK SET) When you turn the ignition switch to ON after installation, [SET UP :YES] appears in the display. 1 Press the M.C. dial. The setup menu disappears after 30 seconds of no operation. If you prefer not to set at this time, turn the M.C. dial to select [NO], then press to confirm. 2 Turn the M.C. dial to adjust the hour, then press to confirm. The indicator moves to the minute setting automatically. 3 Turn the M.C. dial to adjust the minute, then press to confirm. [QUIT] appears. 4 Turn the M.C. dial to select [YES], then press to confirm. NOTES • You can cancel the menu setting by pressing SRC/OFF. • This setting can be made at any time. See page 12 for more details. Canceling the demonstration display (DEMO OFF) 1 Press the M.C. dial to display the main menu. 2 Turn the M.C. dial to select [SYSTEM], then press to confirm. 3 Turn the M.C. dial to select [DEMO OFF], then press to confirm. 4 Turn the M.C. dial to select [YES], then press to confirm. INITIAL settings 1 Press and hold SRC/OFF until the unit turns off. 2 Press the M.C. dial to display the main menu. 3 Turn the M.C. dial to select [INITIAL], then press to confirm. 4 Turn the M.C. dial to select an option, then press to confirm. NOTE The options vary depending on the unit. 6 En

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
  • 54
  • 55
  • 56
  • 57
  • 58
  • 59
  • 60
  • 61
  • 62
  • 63
  • 64
6
En
Remove the insulation sheet before use.
WARNING
•
Keep the battery out of the reach of children. Should the battery be swallowed, consult a doctor
immediately.
•
Do not expose the battery or remote control to excessive heat such as direct sunlight or fire.
CAUTION
•
There is a potential danger of explosion if the battery is incorrectly replaced. When replacing the
battery, replace it with the same type.
•
Do not handle or store the battery with metallic tools or objects.
•
If the battery leaks, remove the battery and wipe the remote control completely clean. Then install a
new battery.
•
When disposing of used batteries, compliance with governmental regulations or environmental
institutions’ rules that apply in your country/area must be followed that pertain to any special
handling needed for disposal.
•
“Perchlorate Material - special handling may apply.
See www.dtsc.ca.gov/hazardouswaste/perchlorate. (Applicable to California, U.S.A.)”
Important
•
Do not store the remote control in high temperatures or direct sunlight.
•
Do not let the remote control fall onto the floor, where it may become jammed under the brake or
accelerator pedal.
When you turn the ignition switch to ON after installation, [SET UP :YES] appears in the
display.
1
Press the
M.C.
dial.
The setup menu disappears after 30 seconds of no operation. If you prefer not to set
at this time, turn the
M.C.
dial to select [NO], then press to confirm.
2
Turn the
M.C.
dial to adjust the hour, then press to confirm.
The indicator moves to the minute setting automatically.
3
Turn the
M.C.
dial to adjust the minute, then press to confirm.
[QUIT] appears.
4
Turn the
M.C.
dial to select [YES], then press to confirm.
NOTES
•
You can cancel the menu setting by pressing
SRC/OFF
.
•
This setting can be made at any time. See page 12 for more details.
1
Press the
M.C.
dial to display the main menu.
2
Turn the
M.C.
dial to select [SYSTEM], then press to confirm.
3
Turn the
M.C.
dial to select [DEMO OFF], then press to confirm.
4
Turn the
M.C.
dial to select [YES], then press to confirm.
1
Press and hold
SRC
/
OFF
until the unit turns off.
2
Press the
M.C.
dial to display the main menu.
3
Turn the
M.C.
dial to select [INITIAL], then press to confirm.
4
Turn the
M.C.
dial to select an option, then press to confirm.
NOTE
The options vary depending on the unit.
Preparing the remote control
How to replace the battery
Insert the CR2025 (3 V) battery with the plus (+) and
minus (–) poles orientated properly.
Setting the clock (CLOCK SET)
Canceling the demonstration display (DEMO OFF)
INITIAL settings