Pioneer DMH-C2550NEX Installation Manual - Page 7

English 5 cm Leave ample space 5 cm • The cords must not cover up the area shown in the figure below. This is necessary to allow the amplifiers to radiate freely. 1 First attach the supplied side brackets to the LCD screen ( ), then attach them to this unit ( ). After that, connect the monitor cable to the LCD screen ( ). TIP The amount of this unit's protrusion from the dashboard/console can be adjusted by shifting the position of the screw hole of this unit to the factory radio-mounting bracket. make it easiest to pick up the driver's voice. • Be sure to turn off (ACC OFF) the product before connecting the microphone. • Depending on the vehicle model, the microphone cable length may be too short when you mount the microphone on the sun visor. In such cases, install the microphone on the steering column. Mounting on the sun visor 1 Fit the microphone lead into the groove. Do not cover this area Installation using the screw holes on the side of this product Installation tips The following procedure describes how to use the supplied parts to install this product with the LCD screen attached to the unit. It is also possible to install this product so that the LCD screen is separate from the unit. For details, visit the Pioneer website for your region. C5500NEX For some types of vehicles, it is necessary to use an installation kit (sold separately) when installing. For details, visit the Pioneer website for your region. Side bracket (for attaching LCD screen to unit) Binding head screw (5 mm) Be sure to use the screws supplied with this product. Monitor cable Attach the monitor cable to the unit with heat resistant tape (sold separately). 2 Fastening this product to the factory radio-mounting bracket. Position this product so that its screw holes are aligned with the screw holes of the bracket, and tighten the screws at three locations on each side. Use either the binding head screws or flush surface screws, depending on the shape of the bracket's screw holes. Factory radio-mounting bracket If the pawl interferes with installation, you may bend it down out of the way. Dashboard or console Binding head screw (8 mm) or flush surface screw Be sure to use the screws supplied with this product. Installing the microphone • Install the microphone in a place where its direction and distance from the driver Microphone lead Groove 2 Attach the microphone clip to the sun visor. Microphone clip Clamps Use separately sold clamps to secure En 7