Pioneer DV-400V-S Owner's Manual - Page 46
kHz PCM Out
UPC - 012562856834
View all Pioneer DV-400V-S manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 46 highlights
09 Additional information Problem No audio, or audio is distorted. The analog audio is OK, but there appears to be no digital audio signal. Noticeable difference in DVD and CD volume. Cannot play multichannel audio. Cannot listen to highsampling rate audio through the digital output. Cannot output 96kHz or 88.2kHz digital audio. No DTS audio output. Can't hear effect of Virtual Surround. Remedy • No audio is output during slow motion playback or when scanning discs other than audio CDs. • Some DVD discs do not output digital audio: Switch your amplifier to the player's analog outputs. • Check that the disc is free from dust and dirt, and that it is not damaged (page 42). • Check that all interconnects are firmly inserted. • Check that the plugs and terminals are free of dirt, oxide, etc. and clean if necessary. Also check the cable for damage. • Make sure the player's output is not connected to the amplifier's phono (turntable) inputs. • Check your amplifier/receiver's settings (volume, input function, speaker settings, etc.). • Make sure that the Digital Out setting is set to On (page 35). • Check that the Dolby Digital, DTS and MPEG out settings (page 35) are suitable for your amplifier/receiver-check the instruction manual that came with your amplifier/receiver. • This is due to differences in the audio format and is not a malfunction. • Check that the Dolby Digital, DTS and MPEG Out settings (page 35) are suitable for your amplifier/receiver-check the instruction manual that came with your amplifier/receiver. • Check the audio options available from the disc menu. • Make sure that 96 kHz PCM Out is set to 96 kHz. • As a copy-protection measure, some DVDs do not output 96kHz audio. In this case, even if set to 96 kHz, the player automatically outputs the audio at 48 kHz. This is not a malfunction. • Check that 96 kHz PCM Out is set to 96 kHz. • Some discs are digital copy protected and do not output high sampling rate digital audio. In this case the output is automatically downsampled. • If this unit is connected to a non-DTS compatible amplifier or decoder using a digital audio cable, set DTS Out to DTS > PCM (page 35). If you do not do this, noise will be output when you play a DTS disc. • If this unit is connected to a DTS-compatible amplifier or decoder using a digital audio cable, check the amplifier settings, and that the cable is properly connected. • The effectiveness of Virtual Surround varies with the disc. 46 En