Pioneer DV-600AV-S Operating Instructions - Page 55
Digital Out
UPC - 012562858845
View all Pioneer DV-600AV-S manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 55 highlights
Additional information 09 Problem Remedy Settings are canceled. • When the power is cut due to power failure or by unplugging the power cord, settings will be canceled: Press STANDBY/ON on the front panel to turn the player off. Wait for --OFF-- to disappear from the display, then unplug the power cord. The remote control doesn't seem to work. • The remote control is too far from the player, or the angle with the remote sensor is too wide: Use the remote within its operating range (page 18). • The batteries are exhausted: Put in new ones (page 6). No picture/No color. • Incorrect video connections: Check that connections are correct and that plugs are inserted fully. Also check the video cable for damage. • TV/monitor or AV amplifier settings are incorrect: Check the instruction manual of the connected equipment. • The video output is set to progressive but your TV/monitor is not compatible with progressive scan: See page 13 for how to set to Interlace. Screen is stretched or • The TV Screen setting in the Initial Settings menu is incorrect. See aspect does not change. page 52 for how to set it correctly for your TV/monitor. Picture disturbance during playback or the picture is dark. • This player is compatible with Macro-Vision System copy guard. Some discs include a copy prevention signal, and when this type of disc is played back, stripes etc., may appear on some sections of the picture depending on the TV. This is not a malfunction. • Due to the player's copy protection circuits, connection of this device through a VCR or an AV selector may prevent recording or cause picture problems. This is not a malfunction. No audio, or audio is distorted. • No audio is output during slow motion playback or when scanning discs other than audio CDs and SACDs. • Some DVD discs do not output digital audio: Switch your amplifier to the player's analog outputs. • Check that the disc is free from dust and dirt, and that it is not damaged (page 51). • Check that all interconnects are firmly inserted. • Check that the plugs and terminals are free of dirt, oxide, etc. and clean if necessary. Also check the cable for damage. • Make sure the player's output is not connected to the amplifier's phono (turntable) inputs. • Check your amplifier/receiver's settings (volume, input function, speaker settings, etc.). The analog audio is OK, but there appears to be no digital audio signal. • Make sure that the Digital Out setting is set to On (page 39). • Check that the Dolby Digital, DTS and MPEG out settings (page 39) are suitable for your amplifier/receiver-check the instruction manual that came with your amplifier/receiver. • SACDs and some DVD-Audio discs do not output digital audio. Listen through the player's analog audio outputs. Noticeable difference in • This is due to differences in the audio format and is not a DVD and CD volume. malfunction. 55 En