Pioneer P90HDD Other Manual - Page 3

Installation Installing the power box (Fig. 12) The power box has velcro tape on the underside to secure it to the car mat. • Wipe the surface thoroughly before affixing the velcro tape. Velcro tape Car mat Fig. 12 About the fixing screws for the front panel (Fig. 13) If you do not operate the Detaching and Replacing the Front Panel Function, use the supplied fixing screws and fix the front panel to this unit. Fixing screw Fig. 13 Installing the Steering Remote Control Unit WARNING • Avoid installing this unit in such a location where the operation of safety devices such as airbags is prevented by this unit. Otherwise, there is a danger of a fatal accident. • Avoid installing this unit in such a location where the operation of the steering wheel and the gearshift lever may be prevented. Otherwise, it may result in a traffic accident. CAUTION • Installation of this unit requires specialized skills and experience. Installation of this unit should be entrusted to a dealer from whom you purchased this unit. • Install this unit using only the parts supplied with this unit. If other parts are used, this unit may be damaged or could dismount itself, which leads to an accident or trouble. • Install this unit as required by this manual. Failure to do so may cause an accident. • Do not install this unit near the doors where rainwater is likely to be spilled on the unit. Incursion of water into the unit may cause smoke or fire. WARNING • Fix this unit securely to the steering wheel with the belt attached to the unit. If this unit is loose, it disturbs driving stability, which may result in a traffic accident. • Do not attach this unit to the outer circumference of the steering wheel. Otherwise, it disturbs driving stability, causing a traffic accident. Always attach this unit to the inner circumference of the steering wheel as shown. (Fig. 14) Note: • Do not install this unit in such a place as may obstruct the driver's view. • Since interior layout differs depending on the type of vehicle, the ideal installation location for the unit also differs. When installing the unit, select a location that assures optimum transmission of signals from the unit to the car stereo. Fig. 14 Installing the Unit on a Left-HandDrive Car Note: • When the unit is installed on a right-hand-drive car, the horizontal positions are inverted. 1. Secure inner holder to the inner circumference of the steering wheel with belt. (Fig. 15) • Fit the inner holder to the steering wheel so that the arrow-marked side faces the driver as shown below. Inner holder 3. Install outer holder on the inner holder and secure with screws. (Fig. 17) • Tighten the screws with the supplied hexagonal wrench. Screw Outer holder Belt Fig. 15 2. Cut the extra portion of the belt at the center of the inner holder. (Fig. 16) Fig. 17 4. Install the remote control unit in the holder. (Fig. 18) • When removing the remote control unit from the holder, move the corrugated release section toward the steering wheel and slide the remote control unit toward you. Fig. 16 Release Section Fig. 18