Pioneer PD-10AE Refurbished Instruction Manual English - Page 14
Connecting the Power Cord
View all Pioneer PD-10AE Refurbished manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 14 highlights
Connecting the CD Player-Continued Using centralized control with other Pioneer components (PD-30AE only) By connecting Pioneer brand components with control jacks with monaural miniplug cables (without resistors), you can centralize control of the devices using the remote controller of this unit. This also allows remote control of components not equipped with a remote sensor, or installed in places where the component's remote sensor cannot be accessed. Note: • When connecting the CONTROL IN/OUT jacks, supplied analog audio cables must also be used to make analog connections. Merely connecting the CONTROL IN/OUT jacks alone will not allow proper system control. • When a monaural miniplug cable is connected to the PD-30AE's CONTROL IN jack, the unit cannot be controlled by pointing the remote control at the PD-30AE (the remote sensor is automatically disabled). Aim remote control at the sensor on the PD-30AE. Monaural miniplug cable (without resistor) (not supplied) Other Pioneer component equipped with CONTROL IN/OUT jacks To other Pioneer component equipped with CONTROL IN jack Connecting the Power Cord Before connecting the power cord, connect all of the other components. Plug the power cord into a suitable electrical outlet En-14