Pioneer PD-R555RW Operating Instructions - Page 108

TROUBLESHOOTING In case of trouble, first check the following list. What seems to be a failure of the unit is sometimes due to imperfect maintenance, defective disc or unaccustomed operation. Such troubles are often recovered by correcting simple mistake or misunderstanding or by simple maintenance operation. If your trouble cannot be recovered after checking the following list, please call you nearest PIONEER service center or station. Self-diagnostics This unit incorporates a self-diagnostic function. When it detects trouble during an operation, it displays one of the following messages on the display panel. Display Alternate display of "CHECK and "DISC" Display blinks "CHECK" Cause Treatment Ref. Page The disc is stopped due to dirt, stain, Take out the disc and check for dirt, dust, scratch, etc. scratch or vibration. page 18 The disc may be loaded upside down. Take out and check the disc. page 38 If the same messages are displayed again after the disc is reloaded, unplug the power cord and plug it in again. If the same messages are displayed again, please contact a PIONEER authorized service center. A system error occurred perhaps due to Unplug the power cord and plug it in again. noise or static electricity. If the same messages are displayed again, please contact a PIONEER authorized service center. Information messages related to recording operation Display Alternate display of "CAN NOT" and "COPY". Cause Digital musical signal containing copy inhibit signal based on SCMS is being input. Treatment Ref. page Record the source through analog input or record copy- page 58 permitted music. Alternate display of "CAN NOT" and "REC". The digital input is interrupted. The data (CD-ROM, etc.) provided cannot be recorded. Check if the digital input cable is not disconnected and if the power of the source player is on. Check whether the source is a regular music source. page 20 page 62 Cyclic display of "CHECK", "INPUT" and "CD ?". The source player was already playing Stop playing the source player. page 44 when the DIGITAL SYNCHRO button In a while, "1-SYNC" or "AL-SYNC" is displayed, and the unit page 48 was pressed. is set to the synchro recording standby mode. page 50 Alternate display of The unit is making preparations for Wait until these messages disappear. "SET" and "UP". recording. "REPAIR" Because the disc was left in the unit after recording and the power plug was unplugged later, the track number and recording time data have been cleared without being recorded on the disc. While "REPAIR" is displayed, the track number and recording time data are repaired by tracking the recorded area. Further recording or finalization is possible whenever the display returns to the previous condition. Tracing of the recorded area takes about 40 minutes if the disc has been recorded fully. "REC FULL" No more recording is possible because the available recording time of the disc has been used fully or 99 tracks have already been recorded on the disc. Replace the disc with a new one. Erase a CD-RW disc. page 42 page 78 "Pro DISC" The loaded disc is a CD-R or CD-RW disc Load a CD-R or CD-RW disc with "FOR CONSUMER" page 14, 42 for professional use without "FOR indication. CONSUMER" indication. Take out and check the disc. Information messages related to playback operation Display Cause Treatment Ref. page "NEW DISC" "NO DISC" A blank disc is loaded. An attempt is made to play a blank disc. An attempt is made to start playback without loading a disc. The loaded disc is a blank CD-R or CD-RW disc. Recording is possible but playback is not. Open the tray and check if a disc is loaded. page 16 page 38 page 38 "RESUME" The unit is resuming an operation. After the power supply is cut off by a power failure or by mistake during recording, the unit enters RESUME mode so that additional recording is possible. Wait until the message disappears. page 62 page 76 108 En/Fr