Pioneer PDP-5045HD Owner's Manual - Page 69

Appendix 14 English Troubleshooting Problem • No power. Possible Solution • Make sure the Plasma Display and the Media Receiver are connected correctly. (See page 18.) • Is the power cord disconnected? (See page 23.) • Has the main power been turned on? (See page 24.) • Check if you pressed TV on the remote control unit. (See page 24.) If the indicator on the system lights up red, press TV . • Green and red rectangles appear on • Check if the system cable has been disconnected or almost disconnected? (See page 18.) the screen alternately. • The system cannot be operated. • External influences such as lightning, static electricity, etc., may cause improper operation. In this case, operate the system after first turning the power of the Plasma Display and the Media Receiver, or unplugging the power cord and re-plugging it in after 1or 2 minutes. • Remote control unit does not operate. • Is the Mode switch set correctly? Slide it to the TV setting position. (See page 14.) • Are batteries inserted with polarity (+, -) aligned? (See page 20.) • Are batteries worn out? (Replace with new batteries.) (See page 20.) • Operate the remote control unit while pointing it toward the remote control sensor on the Plasma Display. (See page 20.) • Are you using it under strong or fluorescent lighting? • Is a fluorescent light illuminated near the remote control sensor? • No image and audio is presented. • Check if the input source for video or PC has been unintentionally selected although you want to watch a TV channel. (See page 25.) • Check if you have activated the Parental Control function. (See page 33.) Enter a password to temporarily cancel the Parental Control function. (See page 37.) • No picture. • Is connection to other components correct? (See pages 50 to 58.) • Is a non-compatible PC signal being input? (See page 58.) • Is picture adjustment correct? (See page 41.) • Audio is output but no image is presented. • Check if you have selected "Picture Off " for Energy Save. With this option selected, the screen is deactivated; only audio is output. To restore the screen display, press any button other than VOL +/- and MUTING. (See page 43.) • Images are presented but no audio is output. • Check if you have selected the minimum volume. (See page 26.) • Check if you have muted sound. (See page 26.) • When using a video or PC input source, check that the audio terminal is also in connection. (See pages 50 to 54 and 58.) • Sound is reversed between the right • Check if the speaker cable connections have been reversed between the right and left or if the and left. speaker cable from either speaker has been disconnected. (See pages 12 and 18.) • Sound is output from only a single • Has the balance been correctly adjusted? (See pages 42 and 43.) speaker. • Picture is cut off. • Is the image position correct? (See pages 44 and 45.) • Has the correct screen size been selected? (See page 46.) • Strange color, light color, dark or color misalignment. • Adjust the picture tone. (See page 41.) • Is the room too bright? The picture may look dark in a room that is too bright. • Power is suddenly turned off. • Is the sleep timer set? (See page 40.) • Check the power control setting. (See pages 43 and 44.) • The system's internal temperature has increased. Remove any objects blocking vent or clean. (See pages 15 and 16.) Code SD04 SD05 SD11 Message Powering off. Internal temperature too high. Check temperature around PDP. Powering off. Internal protection circuits activated, Is there a short in speaker cable? Powering off. Internal temperature too high. Check temperature around media receiver. Check Check if the ambient temperature of the Plasma Display is high. Check the speaker cable connections between the Plasma Display and the speakers. Check if the ambient temperature of the Media Receiver is high. 69 En