Pioneer PRS-D1200M Owner's Manual - Page 16

Installation Attaching the bass boost remote control Attach with tapping screws (3 mm × 10 mm) at an easily accessible location such as under the dashboard. Tapping screw (3 mm × 10 mm) Example of installation on the floor mat or on the chassis 1. Place the amplifier where it is to be installed. Insert the supplied tapping screws (4 mm × 30 mm) into the screw holes. Push on the screws with a screwdriver so they make marks where the installation holes are to be located. 2. Drill 2.5 mm (1/8 inch) diameter holes at the point marked, and install the amplifier, either on the carpet or directly to the chassis. Replacing the top cover 1. Align the unit and top cover, and insert the screw. • The cover can be installed in the desired direction to match to the amplifier. 2. Tighten the screw with a 4 mm hexagonal wrench. Screw Top Cover Tapping-screws (4 mm × 30 mm) Floor mat or chassis Drill a 2.5 mm (1/8 inch) diameter hole 15