Pioneer PRS-D1200SPL Owner's Manual - Page 4
Setting the Unit
UPC - 012562858906
View all Pioneer PRS-D1200SPL manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 4 highlights
Setting the Unit MODE SELECT Switch You can select amplifier's sync mode from MASTER, SYNC and SYNC INV. Set the MODE SELECT switch to the MASTER position when using one amplifier only. When using synchronously connecting two or more of these amplifiers in combination, set the first amplifier to MASTER, and set the remaining amplifiers to SYNC or SYNC INV according to the manner in which they are connected. The only time the amplifier is switched to the SYNC INV mode is when amplifiers are synchronously connected with the ex. bridge. When switching to the SYNC or SYNC INV mode, remove the screw and stopper. Remove the screw and stopper after checking that connections are correct. See the "Connecting the Speaker Wires" section for details on the MODE SELECT switch. Terminal Cover Before setting up the unit, unfasten the screws with a 4 mm hexagonal wrench and remove the terminal cover. Bass Boost Frequency Control You can select a bass boost frequency from 40 Hz to 120 Hz with the bass boost control. Bass Boost Level Control You can select a bass boost level from 0, 6, 9 and 12 dB. For instruction of connecting the bass boost remote control to the amplifier, see the "Connection Diagram" section. 3 Cut Off Frequency Control for LPF You can select a cut off frequency from 40 Hz to 240 Hz.