Pioneer PRS-D2200T Owner's Manual - Page 16

ASpTeictilfeic(aEtniognlissh) Power source ...14.4 V DC (10.8 V to 15.1 V allowable) Grounding system ...Negative type Current consumption ...25 A (at continuous power, 4 Ω) Average current drawn* ...8 A (4 Ω for two channels) 17 A (4 Ω for one channel) 17 A (2 Ω for two channel) Fuse ...30 A × 2 Dimensions ...301 (W) mm × 57 (H) mm × 213 (D) mm [12 (W) in. × 2-1/4 (H) in. × 8-3/8 (D) in.] Weight ...3.4 kg (7.5 lbs.) (Leads for wiring not included) Maximum power output 300 W × 2 (4 Ω) / 1 200 W × 1 (4 Ω) Continuous power output 150 W × 2 (at 14.4 V, 4 Ω, 20 Hz to 20 kHz 1.0% THD) 600 W × 1 (at 14.4 V, 4 Ω, 1 kHz 1.0% THD) 300 W × 2 (at 14.4 V, 2 Ω, 1 kHz 1.0% THD) Load impedance ...4 Ω (2 Ω to 8 Ω allowable) Frequency response ...10 Hz to 50 kHz (+0 dB, -3 dB) Signal-to-noise ratio ...100 dB (IHF-A network) Distortion ...0.005 % (10 W, 1 kHz) Separation ...70 dB (1 kHz) 60 dB (100 Hz to 10 kHz) Low pass filter ...Cut off frequency: 40 Hz to 500 Hz Cut off slope: -12 dB/oct High pass filter ...Cut off frequency: 40 Hz to 500 Hz Cut off slope: -12 dB/oct Bass boost ...Frequency: 50 Hz Level: 0, 6, 9, 12 dB Gain control ...RCA: 400 mV to 6.5 V Speaker: 1.6 V to 26 V Maximum input level / impedance ...RCA: 6.5 V / 22 kΩ Speaker: 26 V / 90 kΩ Power output 150 W RMS × 2 channels (4 Ω and 1 % THD+N) 600 W RMS × 1 channel (4 Ω and 1 % THD+N) 300 W RMS × 2 channels (2 Ω and 1 % THD+N) Signal-to-noise ratio 80 dBA (Reference: 1 W into 4 Ω) Note: • Specifications and the design are subject to possible modification without notice due to improvements. *Average current drawn • The average current drawn is nearly the maximum current drawn by this unit when an audio signal is input. Use this value when working out total current drawn by multiple power amplifiers. 15