Pioneer SPH-DA02 User Manual - Page 28
Troubleshooting, Appendix
View all Pioneer SPH-DA02 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 28 highlights
Appendix Appendix Troubleshooting If you have problems operating this product, refer to this section. The most common problems are listed below, along with likely causes and solutions. If a solution to your problem cannot be found here, contact your dealer or the nearest authorized Pioneer service facility. Problems with this product Symptom Cause Action (Reference) The power doesn't turn on. This Leads and connectors are incor- product doesn't operate. rectly connected. Confirm once more that all connections are correct. The fuse is blown. Rectify the reason for the fuse blowing, then replace the fuse. Be very sure to install a correct fuse with the same rating. Noise and other factors are causing Press the Reset button. the built-in microprocessor to operate incorrectly. The screen is too bright. Picture quality adjustment of the display is not correct. Adjust the picture quality. (Page 23) The display is very dim. The vehicle's light is turned on, and Set "Dimmer" to "OFF". (Page 23) "Dimmer" is selected on "ON". Picture quality adjustment of the display is not correct. Adjust the picture quality. (Page 23) No sounds of audio source are produced. The volume level will not rise. The volume level is low. The mute is on. A speaker lead is disconnected. Adjust the volume level. Turn the mute off. Check the connection. The person on the other end of the phone call cannot hear the conversation due to an echo. The voice from the person on the Use the following methods to reduce the other end of the phone call is output echo: from the speakers and then picked -Lower the volume on the receiver up by the microphone again, creat- -Have both parties pause slightly before ing an echo. speaking There's no picture. The parking brake cord is not con- Connect the parking brake cord, and apply nected. the parking brake. The parking brake is not applied. Connect the parking brake cord, and apply the parking brake. The screen is turned off. ! Touch anywhere on the screen to turn it back on. ! Set "Screen OFF" to "OFF". (Page 23) Nothing is displayed and the touch panel keys cannot be used. The setting for the rear view camera Select the appropriate setting for the rear is incorrect. view camera. The shift lever was placed in [R] Select the correct polarity setting for "Rear when the rear view camera was not Camera". (Page 23) connected. 28 En