Pioneer V8000 Owner's Manual - Page 76
Other Operation Devices
UPC - 012562808086
View all Pioneer V8000 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 76 highlights
07 Function for Commercial Use Other Operation Devices In addition to a DVD mouse, the DVD-V8000 can be used with input devices such as pen tablets and touch panel devices. Consult the Pioneer website for information on devices confirmed to operate properly with the DVD-V8000. Important ¶ When using a touch panel device with a plasma display, set the display setting to [FULL]. Calibration of pen tablet/ touch panel devices Following the procedures noted below to calibrate an LCD pen tablet or touch panel device. Calibration is performed to correct deviations in the cursor position. Results of the calibration are stored inside the player, so recalibration is not required each time the unit is turned ON. Important ¶ This unit does not support simultaneous use of multiple LCD pen tablets or touch panel devices. In addition, only the last-performed calibration results are effective. As a result, recalibration is required if a device is replaced by another device. [Calibration] 1. Press the SETUP button to display the SETUP menu, then use the cursor buttons to select [Initial Settings], and press the ENTER button to confirm (page 39). 2. Press the down cursor button («) to select [Options]. Initial Settings Digital Audio Out Video Output Language Display Options Parental Lock DVI Settings Pointer Calibration Off (us) 3. Use the cursor buttons to select [Pointer Calibration]. Initial Settings Digital Audio Out Video Output Language Display Options Parental Lock DVI Settings Pointer Calibration Off (us) Note ¶ [Pointer Calibration] will be displayed only when a device supported by the DVD-V8000 is connected. 4. Press the ENTER button. ¶ The calibration menu will be displayed. Touch the cross center in the center part of this screen. When you abort this operation, push RETURN button of the player. 5. As instructed by the menu, touch the [+] mark at the center of the screen. 6. Next, touch the [+] mark at the upper left of the screen. 7. Next, touch the [+] mark at the lower right of the screen. ¶ The following display will appear when the [+] mark is touched. YES CANCEL RETRY Would you like to save the calibration settings? Touch the button of "YES", or "CANCEL" or "RETRY". 8. Press either the [YES] on the screen or ENTER button. ¶ The calibration results are stored, and the [Initial Settings] menu is displayed. ¶ If [CANCEL] is pressed, the calibration results are canceled and not saved. ¶ If [RETRY] is pressed, the calibration operation is started again. Important ¶ If the RETURN button is pressed while performing calibration, the [Initial Settings] menu will be redisplayed, and the results of the calibrated will be canceled. The calibration results will also be canceled if the ENTER button is not pressed before the calibration screen disappears (about 5 minutes). 76