Pioneer VSX-26TX Owner's Manual - Page 78

Techno Tidbits & Problem-solving Specifications VSX-27TX : Amplifier Section Continuous average power output of 120 watts* per channel, min., at 6 ohms, from 20 Hz to 20,000 Hz with no more than 0.09 %** total harmonic distortion (front). VSX-26TX: Continuous average power output of 100 watts* per channel, min., at 8 ohms, from 20 Hz to 20,000 Hz with no more than 0.09 %** total harmonic distortion (front). VSX-24TX : Continuous average power output of 90 watts* per channel, min., at 8 ohms, from 20 Hz to 20,000 Hz with no more than 0.09 %** total harmonic distortion (front). VSX-27TX : Continuous Power Output Front 120 W + 120 W (20-20 kHz, 0.09 %, 6 Ω) Center 120 W (20-20 kHz, 0.09 %, 6 Ω) Rear 120 W + 120 W (20-20 kHz, 0.09 %, 6 Ω) VSX-26TX : Continuous Power Output Front 100 W + 100 W (20-20 kHz, 0.09 %, 8 Ω) Center 100 W (20-20 kHz, 0.09 %, 8 Ω) Rear 100 W + 100 W (20-20 kHz, 0.09 %, 8 Ω) VSX-24TX : Continuous Power Output Front 90 W + 90 W (20-20 kHz, 0.09 %, 8 Ω) Center 90 W (20-20 kHz, 0.09 %, 8 Ω) Rear 90 W + 90 W (20-20 kHz, 0.09 %, 8 Ω) Input (Sensitivity/Impedance) PHONO MM 4.7 mV/47 kΩ VCR 1, VCR 2, DVD/LD, TV/SAT, VIDEO, CD, MD/TAPE 1, TAPE 2 335 mV/47 kΩ Phono Overload level (T.H.D.0.1 %, 1kHz) PHONO MM 120 mV Frequency Response PHONO MM 20 Hz to 20,000 ± 0.3 dB VCR 1, VCR 2, DVD/LD, TV/SAT, VIDEO, CD, MD/TAPE 1, TAPE 2 5 Hz to 100,000 Hz +0 -3 dB Output (Level/Impedance) VCR 1 REC, VCR 2 REC, MD/TAPE 1 REC, TAPE 2 REC ..... 335 mV/2.2 kΩ Tone Control BASS 6 dB (100 Hz) TREBLE 6 dB (10 kHz) LOUDNESS 3 dB (100 Hz/10 kHz) Signal-to-Noise Ratio (IHF, short circuited, A network) PHONO MM 80 dB VCR 1, VCR 2, DVD/LD, TV/SAT, VIDEO, CD, MD/TAPE 1, TAPE 2 101 dB Signal-to-Noise Ratio [EIA, at 1 W (1 kHz)] PHONO MM 80 dB VCR 1, VCR 2, DVD/LD, TV/SAT, VIDEO, CD, MD/TAPE 1, TAPE 2 83 dB 78 * Measured pursuant to the Federal Trade Commission's Trade Regulation rule on Power Output Claims for Amplifiers. ** Measured by Audio Spectrum Analyzer. VIDEO Section Input (Sensitivity/Impedance) VCR 1, VCR 2, DVD/LD, TV/SAT, VIDEO 1 Vp-p/75 Ω Output (Level/Impedance) VCR 1, VCR 2, MONITOR 1 Vp-p/75 Ω Frequency Response VCR 1, VCR 2, MONITOR 5 Hz to 10 MHz +0 -3 dB Signal-to-Noise Ratio 65 dB FM Tuner Section Frequency Range 87.5 MHz to 108 MHz Usable Sensitivity Mono: 13.2 dBf, IHF (1.3 µV/75 Ω) 50 dB Quieting Sensitivity Mono: 20.2 dBf Stereo: 38.6 dBf Signal-to-Noise Ratio Mono: 73 dB (at 85 dBf) Stereo: 70 dB (at 85 dBf) Distortion Stereo: 0.5 % (1 kHz) Alternate Channel Selectivity 60 dB (400 kHz) Stereo Separation 40 dB (1 kHz) Frequency Response 30 Hz to 15 kHz (± 1) dB Antenna Input 75 Ω unbalanced AM Tuner Section Frequency Range 530 kHz to 1,700 kHz Sensitivity (IHF, Loop antenna 350 µV/m Selectivity 25 dB Signal-to-Noise Ratio 50 dB Antenna Loop antenna Miscellaneous Power Requirements AC 120 V, 60 Hz VSX-27TX : Power Consumption 460 W, 630 VA Power Consumption in Standby mode 1.0 W AC Outlet SWITCHED (×2 Total 100 W (0.8 A) MAX AC Outlet UNSWITCHED 100 W (0.8 A) MAX Dimensions 420 (W) × 173 (H) × 470 (D) mm 16-9/16 (W) × 6-13/16 (H) × 18-1/2 (D) in Weight (without package 14.7 kg (32 lb 7 oz) VSX-26TX/24TX : Power Consumption 400 W, 550 VA Power Consumption in Standby mode 1.0 W AC Outlet SWITCHED (×2 Total 100 W (0.8 A) MAX AC Outlet UNSWITCHED 100 W (0.8 A) MAX Dimensions 420 (W) × 173 (H) × 470 (D) mm 16-9/16 (W) × 6-13/16 (H) × 18-1/2 (D) in Weight (without package 14.1 kg (31 lb 1 oz) Furnished Parts FM Antenna 1 AM Loop Antenna 1 Dry Cell Batteries (SIZE "AA" (IEC LR6 2 Remote Control Unit 1 Operating Instructions 1 NOTE: Specifications and the design are subject to possible modifications without notice, due to improvements.