Pioneer VSX23TXH Owner's Manual - Page 79

The Advanced MCACC menu 10 2nd reference point 1 3rd reference point 2 3 Main listening position 3 Connect the microphone to the MCACC SETUP MIC jack on the front panel. • Push down on the PUSH OPEN tab to access the MCACC SETUP MIC jack. Make sure there are no obstacles between the speakers and the microphone. VSX-23TXH: CONTROL ON / OFF MASTER VOLUME MCACC SETUP MIC iPod iPhone USB VIDEO CAMERA HDMI 4 VSX-21TXH: USB iPod iPhone VIDEO 2 INPUT VIDEO L AUDIO R CONTROL ON / OFF MCACC SETUP MIC USB iPod iPhone VIDEO 2 INPUT VIDEO L AUDIO R MCACC SETUP MIC MASTER VOLUME If you have a tripod, use it to place the microphone so that it's about ear level at your normal listening position. If you do not have a tripod, use some other object to install the microphone.1 4 When you're finished setting the options, select START then press ENTER. 5 Follow the instructions on-screen. • Make sure the microphone is connected. • If you're using a subwoofer, it is automatically detected every time you switch on the system. Make sure it is on and the volume is turned up. • See Problems when using the Auto MCACC Setup on page 43 for notes regarding high background noise levels and other possible interference. 6 Wait for the Auto MCACC Setup to finish outputting test tones. A progress report is displayed on-screen while the receiver outputs test tones to determine the speakers present in your setup. Try to be as quiet as possible while it's doing this. • Do not adjust the volume during the test tones. This may result in incorrect speaker settings. • With error messages (such as Too much ambient noise! or Check microphone) select RETRY after checking for ambient noise (see Problems when using the Auto MCACC Setup on page 43) and verifying the mic connection. If there doesn't seem to be a problem, you can simply select GO NEXT and continue. 7 If necessary, confirm the speaker configuration in the GUI screen.2 The configuration shown on-screen should reflect the actual speakers you have. If no operations are performed for 10 seconds while the speaker configuration check screen is being displayed, the Auto MCACC Setup will resume automatically. In this case, you don't need to select 'OK' and press ENTER in step 8. 1b.Auto MCACC A/V RECEIVER Now Analyzing... 2/9 Environment Check Ambient Noise : OK Microphone : Speaker YES/NO : Exit Cancel L : C : R : SR : SBR : SBL : SL : SW : 10 OK 1b.Auto MCACC A/V RECEIVER YES YES YES YES YES YES YES YES RETRY Exit Cancel Note 1 It may not be possible to measure correctly if the microphone is placed on a table, sofa, etc. 2 This screen is only shown if you selected ALL or Speaker Setting from the Auto MCACC menu. 79 En