Plantronics 510S VOYAGER User Guide - Page 10

Handset Lifter Optional

Get Plantronics 510S VOYAGER PDF manuals and user guides View all Plantronics 510S VOYAGER manuals
Add to My Manuals
Save this manual to your list of manuals

Page 10 highlights

HANDSET LIFTER (OPTIONAL) 9 OPERATION WITH THE HANDSET LIFTER ACCESSORY The Plantronics Handset Lifter is an accessory that has two functions: • To automatically notify you when an incoming call is detected even when you are away from your desk. • To lift or replace the telephone handset from its cradle even when you are away from your desk. SETTING UP THE HANDSET LIFTER 1. Plug lifter power cord into handset lifter jack on base. 2. Set handset lifter on/off switch on base to "on" (down) position. OFF When set to "on," the base senses when the ON headset has been removed or replaced in the base, automatically activating lifter to answer or end a call. 3. Position lifter under telephone receiver. Tip: Remove only a tiny piece of mounting tape backing to temporarily stick lifter into position-you may need to move it! 4. Press call control button to activate lifter. Dial tone should sound if receiver is raised high enough. If necessary, adjust lifter height switch or re-position lifter under receiver. 5. Use mounting tape to fix lifter in position.

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
9
HANDSET LIFTER (OPTIONAL)
OFF
ON
OPERATION WITH THE HANDSET
LIFTER ACCESSORY
The Plantronics Handset Lifter is an accessory
that has two functions:
•
To automatically notify you when an
incoming call is detected even when
you are away from your desk.
•
To lift or replace the telephone handset
from its cradle even when you are away
from your desk.
SETTING UP THE HANDSET LIFTER
1.
Plug lifter power cord into handset lifter jack
on base.
2.
Set handset lifter on/off switch on base to
“on” (down) position.
When set to “on,” the base senses when the
headset has been removed or replaced in the
base, automatically activating lifter to answer
or end a call.
3.
Position lifter under telephone receiver.
Tip:
Remove only a tiny piece of mounting
tape backing to temporarily stick lifter into
position—you may need to move it!
4.
Press call control button to activate lifter. Dial
tone should sound if receiver is raised high
enough. If necessary, adjust lifter height switch
or re-position lifter under receiver.
5.
Use mounting tape to fix lifter in position.