Polk Audio CSW155 CSW100, 155, 200, SWA500 Cut Sheets - Page 1

THIS DOCUMENT APPLIES TO CSW100, CSW155, CSW200, AND SWA500 PRODUCTS Cutsheet for CSW100/155/200 Custom Install Subwoofers and SWA500 Amplifier CSW100 Custom Install Subwoofer The CSW100 subwoofer is a bandpass design with slot-load venting and has a 10 inch long-throw driver. The CSW100 fits standard joist spacing and is designed specifically for floor and ceiling installation, or custom enclosures that are at least nine inches (9") deep. All sound comes from an opening approximately 13 inches long by 3 inches wide. There is an access panel on the back of the subwoofer should the driver have to be removed for service. Hardware (included) • 1 Subwoofer • 4 Mounting Brackets • 16 - 3/4" Particle Board Panhead Screws • 16 Washers • 3 Isolation Pads • 1 Registration Card • 1 Owner's Manual (also available online) • Plastic molded grille • 6 Rubber Buttons (to cover grille screw holes) Protective Cover A 1/2" thick protective cover of MDF covers the CSW100 grille opening. This protective cover (3 - 1/4" x 13") is also the template you will use to cut the grille opening. Affixed to the MDF cover is the following label: If you choose to use another grille, use one that doesn't resonate and caulk it. Wood Joist Mounting Brackets and Screws All the bass comes out of here! Wood Joist Isolation Pads Top View of CSW100 Subwoofer in floor Available Finishes: Black www.PolkAudio.com / 800.377.7655 (USA & Canada) / 410.358.3600 (Worldwide) 1