Poulan 20112x92e0 User Manual - Page 8
Assemble Spark Plug Boot To, Spark Plug Wire, Install Control Bar, Assemble Engine Zone Control,
View all Poulan 20112x92e0 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 8 highlights
INSTALL CONTROL BAR 1. Position control bar so flattened section with hole is on opposite side of handle as up-stop bracket. 2. Insert one end of control bar into handle hole on inside of handle. Carefully push in on opposite end of control bar and insert into hole on opposite side of handle. Upper handle Up-stop bracket Control bar Engine zone control cable Control bar Up-stop bracket ASSEMBLE ENGINE ZONE CONTROL CABLE TO ENGINE Cable attaches under the brake arm cover, which is opposite the spark plug end of engine. 1. Straighten cable and find the end with the small plastic fitting. 2. Hook the "Z" bend fitting on inner wire of cable into hole in brake arm of engine. 3. Align the tapered end of the small plastic fitting with hole in the mounting bracket and push in until fitting snaps into place. "Z" bend cable fitting INSTALL STARTER ROPE 1. Put threaded end of rope guide through hole in side of upper handle above lower handle crossbar. Secure with 1/4-20 locknut. 2. Hold control bar against upper handle and slowly pull engine starter rope out until rope will slip into loop of rope guide. Rope guide Upper handle Locknut Lower handle crossbar Engine starter rope Brake arm Small plastic fitting Mounting bracket ASSEMBLE SPARK PLUG BOOT TO SPARK PLUG WIRE 1. Remove spark plug wire from spark plug and install boot to wire. ASSEMBLE ENGINE ZONE CONTROL CABLE TO UPPER HANDLE Assemble cable to opposite side of up- 2. Reconnect spark plug wire to spark plug. Spark plug stop bracket. wire 1. Route cable below crossbar of lower handle and up to control bar. 2. Hook "Z" bend fitting on inner wire into hole in control bar. 3. Attach cable fitting to upper handle as shown. 4. Secure cable to lower handle with wire ties. 8 Boot