Poulan 96194000801 User Manual - Page 8

MUFFLER GASOLINE FILLER CAP CHOKE CONTROL SAFETY IGNITION KEY ON / OFF SWITCH PRIMER FUEL SHUT-OFF VALVE RECOIL (AUXILIARY) STARTER HANDLE NOTE: ITEMS ABOVE ARE SHOWN IN THEIR TYPICAL LOCATION ON THE ENGINE. ACTUAL LOCATION MAY VARY WITH THE ENGINE ON YOUR UNIT. OPERATION ELECTRIC START BUTTON POWER CORD PLUG AUGER CONTROL LEVER DEFLECTOR REMOTE CONTROL LEVER DRIVE SPEED CONTROL LEVER CHUTE DEFLECTOR TRACTION DRIVE CONTROL LEVER LIGHT DISCHARGE CHUTE DISCHARGE CHUTE CONTROL KNOB CLEAN-OUT TOOL HANDLE KNOB MUFFLER TOOLBOX AUGERS SKID PLATE FIG. 8 MEETS A.N.S.I. SAFETY REQUIREMENTS Our snow throwers conform to the standards of the American National Standards Institute. Toolbox - used to store spare shear bolts, locknuts and wrench. Throttle/engine control - used to select either FAST or SLOW engine speed and to STOP the engine. Safety ignition key - must be inserted for the engine to start and run. Remove when snow thrower is not in use. Traction drive control lever - used to engage power-propelled forward or reverse motion of snow thrower. Electric start button - used for starting the engine. Auger control lever - used to engage auger motion (throw Recoil (auxiliary) starter handle - used for starting engine. snow). Primer - pumps additional fuel from the carburetor to the cylinder for use when starting a cold engine. Discharge chute control knob - used to change the direction the snow is thrown. Choke control - used for starting a cold engine. Skid plate - used to adjust height of scraper bar from the ground. ON / OFF switch - used to STOP the engine. 8