Poulan 96194000901 User Manual - Page 9

MUFFLER GASOLINE FILLER CAP CHOKE CONTROL OPERATION ELECTRIC START BUTTON POWER CORD PLUG AUGER CONTROL DISCHARGE CHUTE CONTROL LEVER LEVER DRIVE SPEED CONTROL LEVER DEFLECTOR REMOTE CONTROL TRACTION DRIVE CONTROL LEVER LEVER CHUTE DEFLECTOR SAFETY IGNITION KEY ON / OFF SWITCH PRIMER FUEL SHUT-OFF VALVE RECOIL (AUXILIARY) STARTER HANDLE DISCHARGE CHUTE CLEAN-OUT TOOL LH TURN TRIGGER LIGHT HANDLE KNOB NOTE: ITEMS ABOVE ARE SHOWN IN THEIR TYPICAL LOCATION ON THE ENGINE. ACTUAL LOCATION MAY VARY WITH THE ENGINE ON YOUR UNIT. MUFFLER TOOLBOX AUGERS SKID PLATE FIG. 10 MEETS A.N.S.I. SAFETY REQUIREMENTS Our snow throwers conform to the standards of the American National Standards Institute. Toolbox - used to store spare shear bolts, locknuts and wrench. Drive speed control lever - used to select forward or reverse motion and speed of snow thrower. Safety ignition key - must be inserted for the engine to start and run. Remove when snow thrower is not in use. Traction drive control lever - used to engage power-propelled forward or reverse motion of snow thrower. Electric start button - used for starting the engine. Recoil (auxiliary) starter handle - used for starting engine. Primer - pumps additional fuel from the carburetor to the cylinder for use when starting a cold engine. Choke Control - used for starting a cold engine. ON / OFF switch - used to STOP the engine. LH and RH turn triggers - used to steer the snow thrower. Auger control lever - used to engage auger motion (throw snow). Discharge chute control lever - used to change the direction the snow is thrown. Deflector remote control lever - used to change the distance the snow is thrown. Skid plate - used to adjust height of scraper bar from the ground. 9