Poulan HDF550J User Manual - Page 12
Customer, Responsibilities, Service, Adjustments
![]() |
View all Poulan HDF550J manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 12 highlights
CUSTOMER RESPONSIBILITIES MUFFLER Do not operate tiller without muffler. Do not tamper with exhaust system. Damaged mufflers or spark arresters could create a fire hazard. Inspect periodically and replace if necessary. If your engine is equipped with a spark arrester screen assembly, remove every 50 hours for cleaning and inspection. Replace if damaged. SPARK PLUG Replace spark plugs at the beginning of each tilling season or after every 50 hours of use, whichever comes first. Spark plug type and gap setting are shown in "PRODUCT SPECIFICATIONS" on page 3 of this manual. TRANSMISSION Your transmission is sealed and will not require lubrication unless serviced. CLEANING • Clean engine, wheels, finish, etc. of all foreign matter. • Keep finished surfaces and wheels free of all gasoline, oil, etc. • Protect painted surfaces with automotive type wax. Wedonotrecommendusingagardenhose tocleanyourunit unless the muffler, air filter and carburetor are covered to keep water out. Water in engine can result in a shortened engine life. SERVICE AND ADJUSTMENTS CAUTION: Disconnect spark plug wire from spark plug and place wire where it cannot come into contact with plug. TILLER TO ADJUST HANDLE HEIGHT (SEE FIG. 15) Factory assembly has provided lowest handle height. Select handle height best suited for your tilling conditions. Handle height will be different when tiller digs into soil. • If a higher handle height is desired, loosen the four nuts securing handle panel to engine brackets. • Slide handle panel to desired location. • Tighten the four nuts securely. ENGINE BRACKETS HANDLE PANEL NUTS (ALSO 2 / ON LEFT SIDE OF TILLER) CLEVIS PIN A OUTER TINE A 0 0 0 0 B HAIRPIN CLIP INNER TINE FIG. 16 MID-WIDTH TILLING - 24" PATH (See Fig. 17) • Assemble holes "A" in tine hubs to holes "C" in tine shaft. 0 0 0 0 0 0 0 O0 /11 FIG. 17 NARROW TILLING/CULTIVATING - 12-3/4" PATH (See Fig. 18) • Remove outer tines. FIG. 15 TINE ARRANGEMENT Your outer tines can be assembled in several different ways to suit your tilling or cultivating needs. a CAUTION: Tinesare sharp. Wear gloves or otherprotection whenhandlingtines. 0 0 0 0 INNER TINES ONLY NORMAL TILLING - 26" PATH (See Fig. 16) FIG. 18 • Assemble holes "A" in tine hubs to holes "B" in tine shaft. NOTE: When reassembling outer tines, be sure right tine assembly (marked "R") and left tine assembly (marked "L") 12 are mounted to correct side of tine shaft.
![](/manual_guide/products/poulan-hdf550j-user-manual-4ef437d/12.png)